Spigot or Pilot bushing install depth

[ck_chino]

Hey I have 94 r32gtr with pull clutch. I’m installing nismo coppermix twin.  I have a question about bronze pilot bushing installed in crankshaft. How deep should it go? R32 gtr factory service manual states 13 below crankshaft/flywheel boss flange.  I’m guessing 13mm??? Not sure if it makes a difference regardless of pull or push clutch so I was searching on r33 gtr engine manual and they say to bottom it out(I referenced r33 because that generation has pull clutch and r32 fsm only speaks about push clutch) not sure about bushing depth regardless of it is push or pull clutch system

[BK]

Push or pull doesn't matter - gearbox input shaft doesn't know the difference if pull or push as they are the same box and crankshaft.

Just bottom it out.

[Duncan]

But not too hard, give future you a chance to get it back out....

[GTSBoy]

Yeah, I would have said "bottomed out except with 1-2mm left to go, so the grease has a chance to push it out when you go ghetto hydraulic on it".