Jump to content
SAU Community

R33 gtst where does this trunk wire go?


Recommended Posts

2 hours ago, joshuaho96 said:

Pretty sure there's no lock solenoid on the R33 for the trunk, just the cable and the key bellcrank hitting the latch. It's either for a brake light or the switch that activates the trunk light.

Yuh, so both the solenoid and the bootlid stop light would have been aftermarket additions, not factory, hence my reference to an assumption of not being able to find it on the wiring diagram. Wiring diagram being the first port of call for answering these questions.

And....is the switch for the boot light not adjacent the hinge, and not down in the "slam violently" zone near the latch? The wiring for a switch near the hinge would also be shorter and more efficient than unnecessarily locating it at the latch.

Link to comment
Share on other sites

26 minutes ago, GTSBoy said:

Yuh, so both the solenoid and the bootlid stop light would have been aftermarket additions, not factory, hence my reference to an assumption of not being able to find it on the wiring diagram. Wiring diagram being the first port of call for answering these questions.

And....is the switch for the boot light not adjacent the hinge, and not down in the "slam violently" zone near the latch? The wiring for a switch near the hinge would also be shorter and more efficient than unnecessarily locating it at the latch.

I'd have to check again but I'm pretty sure the light switch is in the trunk lid. Why that is I couldn't tell you.

Link to comment
Share on other sites

Hmm. You might be right. I just looked on mine (32, not 33). I have some sort of a little magnetic switch (or something ish) attached to the latch in the lid with a red/black pair, and in the same loom there's a brown/black pair with a 2 pin connector, not attached to anything. It's near the latch, not halfway up the boot lid frame like the OP's photo. It's strange. I've always known that that loom was strapped to the boot frame, yet always assumed that the light switch was near the light itself / the hinge.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Great info @tidi0x  Will definitely be handy for others and maybe me if I decide to keep the shit box H pattern.
    • Bumping this up one last time.... I wanted to follow up on the clutch slave issue. I realized that what the issue comes down to is the pocket is flat milled, and the cylinder does not want rest flat. So in order to mount it correctly you will need to make a spacer for the fingers so the cylinder is floating. I took two plates of aluminum, drilled some holes and was good. I did still need to make the relief cuts in the bell housing, as even with the spacer the bleed section still interferes. The OE bell housing the mounting holes are raised from the housing.       
    • If the event in USA goes ahead will be interesting as it seems the rules will get more cars over here. Apparently the track is laguna seca too. Yeah s15, if I get a the lower dash trims, centre console and change front cross member to standard LCA position will fit clubsprint. See how rules are as i would rather do complete widebody than a bolt on flare to run the 295 with proper clearance.
    • If the car is legal height I can't see it being an issue. Found a thread on reddit that might offer some insight.   I got a ticket from a copper in QLD for my S15 being too low. They had this wheel thing on a stick that they put under the car and it hit my exhaust. Anyhow went to an exhaust shop to get the exhaust tucked up/hung a little higher and I wound the coilovers up a smidge. Don't think I even had to go back to the police station unlike when I got defected for having a carbon bonnet when I brought the S15 from the ACT to QLD and had to replace it and then rock up at a police station and have a yougish female officer who knew nothing about cars confirm that I had changed bonnets. Should have just painted the carbon bonnet yellow to match the rest of the car lol
    • Id like to race in the US i think alot of those track would suit me   For the s15? Youd be stuck between club sprint and the new Open Am wouldnt you depending on how much interior you have left in
×
×
  • Create New...