Jump to content
SAU Community

Recommended Posts

I have a 1993 Type-M R32 Gtst for sale - Queensland: Noosa Heads.

Specs of my car;

1993 - complianced 2003 (I'm the 2nd aussie owner).

White with a sunroof.

Turbo manual.

Fully adjustable Apexi coilovers (height and dumper).

Apexi springs.

Apexi AFC and boost controller.

Apexi pod filter.

Turbo Smart BOV (Brand new).

GTR fuel pump.

3 inch turbo back exhaust.

Stock R33 rims with 80% 225 tires.

MP3 head unit with 400wt 6x9's

Short shit gear stick.

Genuine GTR front bar, grille and bonnet.

Type M side skirts and rear pods

Wingless boot.

Just put in new plugs and fuel filter, and will have its 5000kay service before the car goes.

Has 133,XXX genuine kays, timing belt changed at 90,XXXkays by old owner. New clutch done by old owner as well, kays on new clutch are not known.

I have more pics for GENUINE PEOPLE.

171Leftside-med.JPG

I will take $16,000obo

Link to comment
https://www.sau.com.au/forums/topic/48468-trade-r32-gtst/
Share on other sites

  • 2 weeks later...

Dont know if u are interested but i have a series 4 RX7 with series 5 motor gearbox and diff. Has been resprayed in Ford blueprint comes with 18 inch zanetti wheels, falken azenis rubber, microtech LT-8, 3 inch exhaust, Bosch 910 fuel pump and a few assorted other goodies?

Link to comment
https://www.sau.com.au/forums/topic/48468-trade-r32-gtst/#findComment-995246
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If shift solenoid A is bad, that explains limp mode --- now you're in the same position as I mentioned previously, in that the next step is to confirm loom/wiring integrity from TCU to gearbox connector with a multimeter (the TCU cannot detect a broken wire, which can happen ..ie; rodent damage, loom rubbed through)...and then finally measure resistance (at the gearbox connector) for shift solenoid A ... ...once you confirm shift solenoid A is bad (open circuit, really low or greater than 40ohm resistance), then it's a job ; you have buy a complete solenoid set, get under the car and drop transmission oil pan, and remove valvebody assembly (the solenoids sit on top), replace solenoid set, and reassemble....it's not exactly a fun task, but readily doable.
    • Is it oil smoke or fuel smoke? They smell different.
    • I only use rubber also. I have an intense distrust of silicone for coolant.
    • Clamp meter will probably tell you lies. PWM DC looks a bit like AC (because the voltage is going up and down rapidly), but it is not AC because the voltage never goes negative and the current never reverses direction. But because it looks like AC, and it is happening at high frequency, at can cause wierd reactive effects. Just be warned that you might learn things that are....confusing. Because they aren't necessarily real.
    • Appreciate the detailed response! It's all new technology to me and your suggestion for reducing DC and finding sweet spots seems like a great approach.   I'll chuck a clamp meter on it at the same time and figure out whats happening at different settings to get a good understanding.   Will report back with my findings when I get around to it to help anyone in the future that will be in the same situation as me 😁
×
×
  • Create New...