r34 gtt bosch knock sensors

[flyingsquirel]

Ayoo, anyone on here that could explain how to wire in the bosch knock sensors into an rb25det neo. I took the old ones out and replacing them with the Bosch ones. The old ones have one wire and the new ones require 2, so do I use that one wire that used to go to the sensor and add a ground one or?

Thanks

[Ben C34]

You can't just change knock sensors and expect the factory ecu to be happy.

[flyingsquirel]

sorry forgot to mention that i have a link g4x in the car 

[Ben C34]

  On 23/07/2023 at 12:43 AM, flyingsquirel said:

sorry forgot to mention that i have a link g4x in the car 

Expand  

One wire should be sensor ground on the ecu, so you need to run that to the knock sensors to do it properly.

[flyingsquirel]

and then for the second wire use the factory one?

 

[Murray_Calavera]

Have you not read the ecu wiring diagram/pinout? 

[robbo_rb180]

Run new shielded twin core too. One wire to ecu knock input, other to sensor ground.

 

[Ben C34]

For reference the Link forum is very active and monitored by dudes from link.

[Duncan]

  On 23/07/2023 at 10:33 AM, Ben C34 said:

For reference the Link forum is very active and monitored by dudes from link.

Expand  

I heard they were going to shut it down and move to facebook to destroy the information/crap ratio, and prevent some people from even accessing it

*edit* sorry hang on, that was someone else

[Dose Pipe Sutututu]

  On 24/07/2023 at 9:19 PM, Duncan said:

I heard they were going to shut it down and move to facebook to destroy the information/crap ratio, and prevent some people from even accessing it

*edit* sorry hang on, that was someone else

Expand  

Low blow Duncan lol..

So much Halaltech knowledge down the drain, like how to successfully re-pin & configure a NZ Cam trigger kit.

[tylink720]

Just finished doing this on with my GTT with a Haltech, I ran a new shielded wire to Signal Ground, and used the oem wire for the other side of the plug

Edited July 28, 2023 by tylink720