Turbo feed/return Hardlines/steel braided ptfe

[timmy94]

Someone running AN aluminium hardlines as turbo oil/water feed/return line? 
 

thinking of going this route instead of the ptfe lines.  everytime im trying to fit new fittings with the ptfe hose i end up with the hose chafing against engine or engine mounts or there Will be a Quite bad bend radius causing constant stress/force on the an fittings. 
 

[robbo_rb180]

@Dose Pipe Sutututu has done hard line.

When using braided hose need to have long arc's for bends and plan the run with the right fitting to start and finish then use P clamps to retain it for long runs and also use a protective sleeving where there is potential for rubbing.

Done hundreds of lines in 15 years and only had one line rub through this year from rocks getting between the hose and cross member it was run along.

[Dose Pipe Sutututu]

I did it for the water feed and return only, one day I'll also do the oil feed to kerb my OCD tingles LOL.

[Duncan]

Nissan did it for factory

Still sounds like a lot of work to get right compared to Rob's suggestion...