Jump to content
SAU Community

Recommended Posts

14 minutes ago, Murray_Calavera said:

Ah ok. It would be a lot more accurate to simply say, the car has not been tuned. 

Blowing black smoke on boost is so crazy far from any state of 'tune' that I would not even call it poorly tuned. 

Do you know where the ECU lives? It takes about 10 seconds to access the ECU and we could solve this mystery.

I'm just relaying what my mechanic told me. In my other post i talked about sonething similiar but some mechanics said to me that black smoke "can" be normal. But I'm out of my depth here.

Ecu is usually under the driver footwell? Or ive seen it sometimes on passenger footwells. Couldn't see it either.

If it hasn't been tuned, is it even possible for a car to run well (meaning it feels normal when driving, not thinking about A/F ratios and such) if it hasn't been tuned on a aftermarket ecu?

Either way needs a tune, I'll leave it to the professionals.

 

17 minutes ago, silviaz said:

passenger footwells

Yep, see attached 

19 minutes ago, silviaz said:

If it hasn't been tuned, is it even possible for a car to run well (meaning it feels normal when driving, not thinking about A/F ratios and such) if it hasn't been tuned on a aftermarket ecu?

Yep. For example, you buy a Haltech ECU and upload the Haltech base map, the car will start and feel ok while driving however will have had 0 tuning done (provided the car is essentially stock, the base map will line up). 

If you get a few seconds spare, please remove the passenger kick panel and solve this mystery for me lol. 

R32 ECU Mounting 3.jpg

  • Like 1
9 minutes ago, Murray_Calavera said:

Yep, see attached 

Yep. For example, you buy a Haltech ECU and upload the Haltech base map, the car will start and feel ok while driving however will have had 0 tuning done (provided the car is essentially stock, the base map will line up). 

If you get a few seconds spare, please remove the passenger kick panel and solve this mystery for me lol. 

R32 ECU Mounting 3.jpg

Will do. 

  • Like 1
14 hours ago, Murray_Calavera said:

Yep, see attached 

Yep. For example, you buy a Haltech ECU and upload the Haltech base map, the car will start and feel ok while driving however will have had 0 tuning done (provided the car is essentially stock, the base map will line up). 

If you get a few seconds spare, please remove the passenger kick panel and solve this mystery for me lol. 

R32 ECU Mounting 3.jpg

To add to this.

Apart from some cranky cold starts, the tune that was on my ECU years ago for a relatively stock RB25, was happy to run and boost hard my RB30DET, with a TD07S on it.

It was very out of tune, but would run and drive "like normal". Except AFRs and timing weren't right.

  • Like 1
On 08/08/2024 at 2:58 PM, silviaz said:

I noticed my oil on my rb25 stays gold for about 3,500km roughly. Then goes light brown after that. Probably around 4,500 mark it goes dark brown (this is me driving normally with no / minimal pulls as i blow black smoke when i boost) (when I drain the oil it's black at 5,000 no metal shavings though in the filter or oil)

I noticed now that it's been under 3,000km and it's dark brown. I think it's because I've been doing a few pulls more than usual (pulls means, in first gear going up to 5000-7000 rpm)

My oil doesn't smell like fuel at all, and isn't causing me any issues but I don't want to get bearing wear (yes I'll be getting my car tuned soon to)

I don't know if it's just me or if my oil is a bit thinner (I'm comparing brand new oil to oil that has roughly 2,500km from memory so might not be a good comparision.

haha. I change mine every 1500-2000ks :D

 

4 hours ago, MBS206 said:

To add to this.

Apart from some cranky cold starts, the tune that was on my ECU years ago for a relatively stock RB25, was happy to run and boost hard my RB30DET, with a TD07S on it.

It was very out of tune, but would run and drive "like normal". Except AFRs and timing weren't right.

When you say timing wasn't right are you referring to the timing belt being a tooth off? I think my AFR's are f**ked but will find out soon.

55 minutes ago, silviaz said:

When you say timing wasn't right are you referring to the timing belt being a tooth off?

No, he was saying that the ignition timing (which is what people mean when talking about "timing" wrt a tune) was not correct. Meaning that for any given load cell it could have been too retarded (and thus giving away power) or too advanced (and thus being close to or beyond the point of causing knock, and thus dangerous, and thus silly to drive around while using the engine in such a away as to access that load site).

We know your AFRs are f**ked. You're the one who told us it is blowing black smoke.

  • Like 1
54 minutes ago, silviaz said:

When you say timing wasn't right are you referring to the timing belt being a tooth off? I think my AFR's are f**ked but will find out soon.

The message here essentially is, your fuel mixture and ignition timing can be crazy far away from being optimal however the car feels fine to drive. He isn't talking about the physical timing belt when talking about timing not being correct. 

  • Like 2
6 hours ago, silviaz said:

When you say timing wasn't right are you referring to the timing belt being a tooth off? I think my AFR's are f**ked but will find out soon.

No, the tune was f**ked.
Much like your tune is.

It could end catastrophically for your engine. Either exploding engine, decimated bearings, or just burning the internals of the engine up.

STOP DRIVING THE CAR AND GET IT TUNED / LOOKED AT BY SOMEONE WHO KNOWS WHAT THEY'RE DOING!

  • Like 1
5 hours ago, GTSBoy said:

No, he was saying that the ignition timing (which is what people mean when talking about "timing" wrt a tune) was not correct. Meaning that for any given load cell it could have been too retarded (and thus giving away power) or too advanced (and thus being close to or beyond the point of causing knock, and thus dangerous, and thus silly to drive around while using the engine in such a away as to access that load site).

We know your AFRs are f**ked. You're the one who told us it is blowing black smoke.

Ah right. I guess the CAS is also related to that?

5 hours ago, Murray_Calavera said:

The message here essentially is, your fuel mixture and ignition timing can be crazy far away from being optimal however the car feels fine to drive. He isn't talking about the physical timing belt when talking about timing not being correct. 

Ah ok, makes sense.

18 minutes ago, MBS206 said:

No, the tune was f**ked.
Much like your tune is.

It could end catastrophically for your engine. Either exploding engine, decimated bearings, or just burning the internals of the engine up.

STOP DRIVING THE CAR AND GET IT TUNED / LOOKED AT BY SOMEONE WHO KNOWS WHAT THEY'RE DOING!

I will.

1 hour ago, silviaz said:

Ah right. I guess the CAS is also related to that?

No, on the basis that the CAS shouldn't be f**ked with, and if it is, it should be set back to the correct base timing with a timing light immediately.

  • Like 1
1 hour ago, silviaz said:

Ah right. I guess the CAS is also related to that?

No.

The tune is f**ked. The numbers you put in the computer, aren't right.

 

If you keep driving the car, then it seems you want to take even longer, and spend even more money fixing a broken motor.

  • Like 1
3 hours ago, Alex001 said:

how come someone says, this isn’t a car that should be out on the road right now.

Like the others mentioned, you could do more damage because you're driving a car that isn't running right. It's like lifting at the gym when you've already injured yourself. You're just going to injure yourself more if you keep going, instead you should fix the issue (heal the muscle) before continuing.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sadly I can confirm if you are actually seeking to drift, you will quite easily spin up one wheel. Even if you're going in a straight line. I am not entirely sure of the metrics/terminology here but there's only a certain amount that the helical will actually spin both wheels. I've seen it on video with my own car where two lines of smoke switch over to just one after you really get in to it. Unlike with a clutch diff where you can keep your foot planted until the car regains grip, in my experience with the helical you want to be utilizing traction control allowing LIMITED slip or lifting (partially) when you start to spin up both tyres with a Nissan helical. Which makes them pretty sub optimal for drifting duty. That said... this is probably a helical on numbers alone. Just put the Kazz in
    • Let's just fix the problem by f**king the rest of the gearbox.
    • Unlikely, as per Greg's post. This is not helical diff behaviour unless one wheel is up off the ground. Shimming what? You don't "shim" a mechanical LSD. Probably not in the sense that you have heard of people "shimming" a diff. And the process that Nissan f**kwits call "shimming" a diff involves super-preloading a VLSD cartridge against the side of the diff to create a friction/wear point (in a place that it wasn't supposed to have one) to make the sloppy, useless, viscous diff into a hybrid viscous/mech abortion. In case it isn't clear, I consider the process to be stupid. Nike.
    • How much does the shifter move when the car is in gear with the engine off? If it is more than about 1cm you need to replace your shifter bush. Your shifts will just get crunchier, not faster, with a short shifter unless you also rebuild the whole box
    • I should video mine, will prob do it tomorrow    Between 1st and 3rd, you could fit another two gears. That is how loose and wobbly it is   horrible:(
×
×
  • Create New...