R32 GTR Power Steering Line

[Dustin Frazee]

Anyone have any tips on replacing the high pressure PS line on a R32 GTR? Mine started leaking and got a new one but can not for the life of me figure out how to get the old one off. I took the sway bar off and disconnected the steering shaft but can not figure out how to get the end that connects to the rack out. I did not want to cut the old one off cause if I can not get the old one off I am sure I will not be able to get the new one on. 

[Duncan]

Got a pic of the fitting you are having trouble with? Everything unbolts so it is likely just being difficult.

Plenty of penetrating oil followed by a little carefully directed heat will usually do the trick

[Dustin Frazee]

I got everything unbolted. I just can not maneuver the line out. It is the part from the sensor to the rack and pinion I am having difficulties with. It has the J shaped end and I am not seeing how it can come out. 

[GTSBoy]

So, you've got the tube nuts B and C undone, and you can't get the HP line to come out of the rack? You will have to release it from the various bracket/clamps that attach it to the subframe to you can get enough wiggle.

 

Edited Saturday at 10:48 PM by GTSBoy

[Dustin Frazee]

I have B and C unbolted. I have the line out of the rack and pinion but how and the heck do I get the C end out between the body and engine? I am working on my stock 91 GTR. So it have everything in the way. I did not know if there was something else I need to remove to pull the line out. I am attempting to pull the line towards the front. Everything is still in the car, engine and all. I was hoping the line could be replaced without removing too much, but I search for about a week and could not find any info on how to do it. So I just started removing it hoping I would see the way. All brackets for the line are removed and both ends undone. Just can not figure out how to fish the line between where the sensor is and the C end. I appreciate all the help and after spending an hours staring at and trying to search the topic it I figured I would ask you guys 

[Duncan]

hahah yeah I have only done it with either the engine out or the subframe on the floor.

Assuming you are replacing it, just cut it near where it changes direction. If you are getting one remade from yours, draw a line across where you are going to cut it, so you end up with a marking you can line up again after when it is remade.

[Dustin Frazee]

That was what I was afraid of that it might only be possible with the engine out or at least lifted up. I have a new line from Nissan but not seeing how it will be possible to get the old one out and the new one in. Maybe after a few drinks I will figure something out. Might try removing motor mounts and lifting the engine a bit to get some more clearance. There are just a few weird bends in the line that make it impossible to feed through the openings. 

[GTSBoy]

1 hour ago, Dustin Frazee said:

Might try removing motor mounts and lifting the engine a bit to get some more clearance.

This.

I've only ever contemplated it with the engine out. Was the prime time to f**k off all the nasty HICAS shit.