Jump to content
SAU Community

Recommended Posts

Getting damn epa notice. ;)

Pulled over again 7:50am!! cruising down Hume Highway just near Wodonga going to work. Look up cop sitting on the median strip turning other direction. Look up again as i am turning off onto nice quiet backroad to find cop car positioned in usual liner hunting pose right up my arse. :bs!:

Pull into back road and straight over, procedes with usual rbt then comments that my car is too low (HKS fronts and temporary lowered nismo rears) and how his rbt straw is exactly 100mm yeah yeah. I reach in the glove box and show roadworthy completeted only this Monday.

Then makes open bonnet(first time in 2years of owning R33's), I get out he then has a quick glance inside. Comes over telling me he knows what he is looking whilst leaning one hand on very illegal bov after awhile says "what this" pointing to evc module (should have hidden that damn it). Keeps looking while stoking the pod filter.

"you can close the bonnet now".

"Can you drive the car over there"

pointing to middle of the road. (f#@k me getting shitty now). Then MrPlod trys to climb underneath car with a straw after some dicking around comes up empty. "Open the bonnet" what the. Yes open it again. :D

Has another look asking me wot boost i'am running? "standard the unit is not tuned in to run any thing else". Spends another 5 min looking. Said nothing about bov, safc, boost guage, and would have not have chance of spotting a HKS2535. Tells me boost controller is not epa blah blah blah was just thinking of the time and $$$ to go back to standard. Is it possible for Vic cops to defect NSW reg car or send them for EPA??? i suspect with epa it might be.

:)

Link to comment
https://www.sau.com.au/forums/topic/50819-evc-epaed/
Share on other sites

they can only send to epa not do a full roadworthy, only minor defects

i still havent been pulled over yet and u can hear my screamer 2km away

vic cops also have a 100page book on every part defectable for imports, from boost controllers to powerfcs to inlet plenums etc

Link to comment
https://www.sau.com.au/forums/topic/50819-evc-epaed/#findComment-1008596
Share on other sites

the wonderful, sensible and responsible people at spring street thought it a good idea to add a couple of phrases to the vic roads legislation. The cops only have to 'think' or believe (i cant believe you can use the word think, politician and cop in the same sentance) the car is defectable to justify writing you up. They may not actually know what the fu(k they are looking at, just that it aint standard.

Link to comment
https://www.sau.com.au/forums/topic/50819-evc-epaed/#findComment-1008811
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • That would be interested if it's the case as seems like it would make the job a lot messier but subaru sells OEM gaskets so seems it might of had it.
    • Fuel tank is out. Looks pretty bloody good under (ie above) the fuel tank.  Amazing how good the factory e-coat holds up in the hidden areas.  No where near as much body deadener to get rid of as the front but still not looking forward to it!  Shit of a job.  I'm thinking I might grab a needle scaler and give that a go before I attack it with the angle grinder and wire wheel which is how I did the front 2/3's of the car.  Feels good to be working on the car again but who knows how long it will last!  Hopefully I can get it further forward than where it was prior to this last block of work when I decided to go back 10 steps further down the rabbit hole from where i already was! The problem is, I'm realising how hard it will be to repair and paint the bumpers, which cannot be put back on the car, and have a good paint match. There are also areas where it would be VERY hard to hide the new paint where it transitions from old paint. Like this- There is only one way to do that perfectly and I really dont want to have to do what that means I would have to do... 🤦‍♂️
    • Pretty sure the factory assembly doesn't have any gasket at all, just RTV.
    • I will get a couple cans for sure thanks, I do have 2lt fish oil to spray around the car already.
    • Thought I’d post pics of the packages for those interested. The premium package is #16. Remote start, security with tilt sensor and remote and backup battery, auto fold mirrors and door illumination.    Can post up pics of all the factory options and images from the factory options brochure if people are interested. I have all the dealer books etc for all rv37 models. 
×
×
  • Create New...