I can't fit the front bar on now i installed fmic

[SKYZER 33]

Hi

I have just installed a fmic, i have an m-spec front end which i have trimed the back of the air dam to allow it to fit but the problem is won't fit cause the blinker indicators in the spoiler are are touching the end tanks of the cooler there for i can't get the front end on has any one else encounterd this problem

Also what size thermo fan/s would be the best to get?

[T0nyGTSt]

Seriously...

Mine is a very tight fit - otherwise I'd say relocated your blinkers to your running lights?

T.

[SKYZER 33]

Seriously...

Mine is a very tight fit - otherwise I'd say relocated your blinkers to your running lights?

T.

I was thinking on those lines would it be ok to trim a the corner off the back of the blinker case? than hopefully it will fit

[Driver]

haha

i had to trim my r34 bar big time. ther was so much useless plastic in the way.

[WazR32GTSt]

ditto for the R32 front bar...

i used a cutting tool that attaches to an air compressor. Much like an electric knife for cutting roast i just cut the front bar away in about 2 minutes then put it on all hacked. Can't tell from the front...

cut cut cut!

[gtst25]

I had to trim off the little pipes on the blinkers on my '33. Shit of a job on the steelwork as I didn't have the right tools ( u never have when you need them). If I did it again I'd try a nibbler or air saw etc.

[T0nyGTSt]

Have you seen the pros install an FMIC?

Lots of metal, plastic and fittings to be cut.

Moreso on a car with a front facing plenum.

T.