still overboosting after i installed fmic

[SKYZER 33]

I installed a hybrid fmic kit. i had to drill a hole in the intercooler piping so i could have somewhere to plumb the bleed valve the problem is it is still overboosting

sky high. i have tried three different types of fittings in the cooler piping where you plumb the vacuum hose. any ideas, this is starting to pee me off

[SKYZER 33]

pic of set up

[SKYZER 33]

here is a picture of setup

[2fardown]

Take the bleed valve off and run it without it.

What's that T-Piece you have there? Take that out and block the other vacuum hose up.

[SKYZER 33]

Take the bleed valve off and run it without it.

What's that T-Piece you have there?  Take that out and block the other vacuum hose up.

i just took it out and tried that and it only boosted to 0.45 at lease it ain't overboosting how can i increase it to 0.7 bar

[2fardown]

put the bleed valve back in but make sure you turn it off. There is obviously less of a restriction with the new intercooler which is why your car is overboosting.

[SKYZER 33]

i turned it right down it doesn't seem to matter where you turn the boost controller to it still overboost. anyone?

[Guest Robo's]

Sounds like youve got a leak in the hose going to the Actuator

[SKYZER 33]

there may be but i'll change it anyway and see how it goes

so is set up right though?just want to make sure! boost controller between

intercooler pipe and Actuator and the other one coming off the air intake hose blocked off