Jump to content
SAU Community

XForce 3inch Dump Pipe R33/R32

Collect
 Share

Recommended Posts

Collect Apprentice

Collect

Posted
Posted

I've got for sale 1 brand new XForce 3 inch dump pipe for a R33 or R32.

This pipe runs from the turbo to the cat, and is mild steel.

It was not used as I have decided to sell the car. I preffer pickup or delivery in Melbourne, but postage interstate should be cheap.

Was purchased for $290. Will sell for $240.

[email protected]

Link to comment
https://www.sau.com.au/forums/topic/51593-xforce-3inch-dump-pipe-r33r32/
Share on other sites
TurboX Mentor

TurboX

Posted
Posted
I've got for sale 1 brand new XForce 3 inch dump pipe for a R33 or R32.

This pipe runs from the turbo to the cat, and is mild steel.

It was not used as I have decided to sell the car. I preffer pickup or delivery in Melbourne, but postage interstate should be cheap.

Was purchased for $290. Will sell for $240.

[email protected]

I am interested if suits r32 GTS and has sep WG pipe?

Any pics?

Collect Apprentice

Collect

Posted
  • Author
Posted

It doesn't have a seperate Waste Gate pipe, it has a large 3inch pipe instead of the restrictive factory dump pipe. You will also notice a boost increase of 2 to 4 psi just from fitting it.

I will post pics tonight.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Shoota_77
      Shoota's R33 GT-R RB30/26

      By Shoota_77 · Posted

      Nah no bearings, just slip fit.  Would be a reasonably challenging but not impossible job to modify it to run bearings but I'm hoping that's not necessary as I may have well built one myself if I end up spending hours modifying it!
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Brumbys with good shells are bloody expensive, I've looked at 2 "cheaper" cars, and walked away from both,  plus after some research spare parts are fairly sparce I'm starting to think that I missed the boat on finding a clean one that is straight (ish) and without alot rust I'm starting to think about a old Hilux as panels and other parts are much more available as they sold tens of thousands of them I use to be indecisive but now I'm not sure
    • soviet_merlin
      NC MX5

      By soviet_merlin · Posted

      A Brumby would probably fit a big metal toolbox in the back... this is how it begins  
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Picked up a new OEM boot seal for the MX5 today as the old one got ripped a bit by me being a idiot by seeing if I could fit a large metal tool box in it, it didn't fit, and ripped the seal with the corner of the tool box I am still waiting on time to get the cams and new balancer installed, as well as the repairs to the boot Time will not be an issue soon though
    • MBS206
      Shoota's R33 GT-R RB30/26

      By MBS206 · Posted

      I was more thinking so it doesn't flop around as much rather than for rotating it. Once you have the balance right, it should rotate well enough, depending on how much resistance there is on the pivot. I think you said the pivot point was on a bearing though didn't you?
×
×
  • Create New...