Jump to content
SAU Community

Recommended Posts

Cheers Richard, I live my life a quarter mile at a time. Nothing else matters: not the mortgage, not the store, not my team and all their bullshit. For those ten seconds or less, I'm free.

Also can i has my car back now? D=

Only Women bleed ....

And i cant handle blood. bones the wrong way is fine but a little blood and i feel like passing out

My finger fell on it very lightly

Its a bit sharper than i thought it could get as its cheap gardening tool steel.

Its the one next to the pinkie, so theres no excuse to stop work. Must do some wiring tonight.

DIY Amputation? You have your fingers in many pies Mik, although, sounds like you almost needed one less pie.

That reminds me... time for some pie.

A total power increase of 0.1kW - without facturing in the weight so that will have a 0.1 power loss which brings your power increase to 0kW ! :D

New cool thing is Quad Turbz with 16 cyclz brah.

it would actually restrict flow on my car and reduce the power pretty hard lol

A total power increase of 0.1kW - without facturing in the weight so that will have a 0.1 power loss which brings your power increase to 0kW ! :D

New cool thing is Quad Turbz with 16 cyclz brah.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • What can't be done with a little bit of decking board or similar timber bolted to a hub flange via 2 wheel nuts is not worth talking about.
    • I noticed something. On the tps sensor and the sensor behind the adjustment screw is adjusted towards the far left. Are these screws supposed to be centered? (this sensor was in the same position before the tune as well)  Also attached a photo of where my car usually idles at when warm (sometimes a tiny bit above that). I think I might have screwed up the calculation and it might have better than I thought lol at 750rpm still not 650rpm though.      
    • So for both general interest of engine health, and to rule out any coolant/oil issues, I organised an oil analysis done on the 125,000klm oil Results below, all good, just a bit of fuel dilution which I'm not too worried about
    • This is actually a really good way of measuring what wheels fit. If only there was a similar measurement between hub face and suspension :p That said, it's probably pretty simple to actually measure it all with the wheel off the car for the rear. The front is a bit more complex but.. 
    • Being the top Google search result for R34 wheel-related inquiries, lemme throw down my experience. I calculated that 100mm from hub face to wheel face is about the perfect fitment for my ENR34 sedan.  I've been running 18x8.5s, ET35, with a 1" spacer. So, 8.5in to mm = 216mm. 216/2 = 108mm. 108-35 = 73mm. 73+ 25 (1" to mm) = 98mm.  If you wanna get close to this on dif widths, here are the offsets you'll want: 9" - ET around 15mm 9.5" - ET around 20mm 10" - you're crazy, but ET around 30mm All these should fit perfectly on a non-widebody, non-GTR Skyline. Note that it's probably the absolute max, and you're probably better off running a couple degrees of camber in this config, but it looks great, super flush.
×
×
  • Create New...