Jump to content
SAU Community

Recommended Posts

on pennant hills road today, bout an hour ago.

spotted alot of sponsored cars

list as follows

whiteline evo7

blue s15 with fmic covered with vinyls

2x mini coopers

VK grp A

Maloo ute and porche, both silver with a pink stripe

and a couple classic cars

also saw the donut king r32 GTR on homebush bay drive

all had numbers on the side

this was all within 30mins

is there some sort of event on????

Link to comment
https://www.sau.com.au/forums/topic/54637-is-there-a-track-or-rally-event-on/
Share on other sites

http://www.news.com.au/common/story_page/0...55E1702,00.html

Rally driver dies during race

October 29, 2004

A SEASONED rally driver was killed and his navigator seriously injured in a high-speed crash during the East Coast Targa Rally west of Sydney today.

The driver of a Porsche competing in the event died after he went into cardiac arrest as a result of injuries from the rollover.

The accident happened on a stretch of sealed road between Brewongle and Loxley, east of Bathurst, about 10am (AEST).

Inspector Chris Davey from Bathurst police said the vehicle lost control after passing over a narrow bridge before veering to the left and crashing into a deep creek bed.

"It veered off to the left side of the road and crashed into a ditch, landing on its roof," Insp Davey said.

Medical personnel were able to free the men, both from Victoria.

"Both occupants were released from the vehicle and unfortunately the driver of the vehicle died on scene," Insp Davey said.

The passenger was treated at the scene for suspected spinal, neck and abdominal injuries.

He was airlifted to Nepean Hospital in a serious but stable condition, a spokeswoman for the Confederation of Australian Motor Sport (CAMS) said.

Insp Davey said the circumstances of the accident were being investigated and a report would be made to the coroner.

CAMS would conduct an investigation, he said.

Police and rally organisers today would not name the driver but rally director Tony Pennell said he was highly experienced and had competed in many Australian rallies.

Rally organisers stopped competition for that section of the event after the accident but continued competition for the following stages.

"Extensive rally safety procedures were implemented as a result of the incident," Mr Pennell said in a statement.

"No other competitors were at risk during the incident."

Competition will continue on the final day of the rally tomorrow.

The four-day rally is held on 198km of sealed public roads which are closed for the event.

The rally, first held in 2000, is conducted over at least 37 stages on roads in areas to the north and west of Sydney, extending into the Blue Mountains and around the towns of Lithgow, Bathurst, Oberon and Orange.

AAP

................................................................................

.............................................

:D :D :(

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Bit of an update to this one. Having some issues on the dyno that held us back (boost spiking) and I want to pass some info over you guys and see what you think is wrong with my setup. The current readout on this dyno is 462rwkw on a low reading dyno so keep in mind it is a real world 500rwkw setup on a hub dyno. Don't read into the power figure too much as a sign of the issue. The short and curly of it is: 2.8 Litre Racepace build RB25 NEO N/A Head with VCT (internally standard however ) Borgwarner EFR 8474  Turbosmart 50mm Straight Gate + Mac valve 6Boost Manifold 4" dump to full 4" exhaust (nil restrictions) Wastegate plumbed back in and all angles in the exhaust system are acceptable and not too sharp. GFB SV52 BOV in cooler piping  Turbosmart BOV in EFR Housing   The issue we are having is it comes onto full boost for example at 4000rpm and spikes to 24/25psi, before dropping down to 17psi before slowly rising back up to the target boost of 23psi. It was extremely uncontrollable and the tuner actually had to ramp in boost progrssively with each 1000rpm on each boost setting we selected to try and reduce the amount of spiking. Sometimes we would see a drop of 10psi from the peak at the beginning of the run, to the low, until it took the next 500-1000rpm to stabilise back up to the target boost. The tuner is pretty confident that the straight gate is just a poorly designed product and leaks too much boost upon cracking the gate open and theres no way to fix it other than going to a poppet valve. He's also confient theres no ignition breakdown or floating valves. The fueling is extremely stable as well. Turbo speed is somewhere around the 109,000rpm area. The spanner in the works for me is that prior to this Borgwarner and StraightGate, the car was tuned on -5 twins at a diferent tuner, and he also had issues controlling the boost with it spiking around the same rpm range, so to me this sounds like the same issue and it can't be anything on the turbo side as this was all changed and I think the behaviour is extremely similar, if not the same. We also removed the mac valve and did a run on wastegate pressure and it still spiked and had the same behaviour. My thoughts on possibilities are: Boost Leak VCT Cam Gear isn't reliably activating consistently - (On this however, we did a run with the VCT disabled and the boost still spiked) Turbosmart BOV is not handling the boost? However this seems unlikely to not be able to handle 20psi. I have a couple of logs that I can't make sense of if anybody knows how to read them and can obtain further logs of other parameters if they are not enough, happy to pay for anyones time. The dyno readout with the power figure is the most recent last week. The other picture is from two weeks prior to that where we couldn't break 400kw (we removed the cat), however the issue of the boost control persisted. @Lithium @Piggaz @burn4005 @GTSBoy @discopotato03 I've tagged those that were quite active in recent pages here, no disrespect to those that know turbos well but I missed tagging. Cheers 
    • I recently purchased a 2018 Infiniti Q60, which has an SD card navigation map. I can see my system has options for real time traffic updates etc, and am wondering if there is something I can purchase to get this working? I can see there are at least updated maps for USA and Canada, but nothing for Australia. Surely Infiniti took changing road systems and city expansions into account when they decided to use an inbuilt navigation over Android Auto/Apple Car Play, or are we doomed to drive on streets that don't exist in the navigation system if you drive to a new area?
    • Luckily I didn't put in etch primer as I just found out it's not compatible with my body filler lol. Also just need to sand the panel anywhere between 150-400 grit so I'm in the clear there. It does say to not apply to soft old paint, I assume that means paint that is flaking, peeling,etc
    • @dbm7 and @GTSBoy thank you both very much! will give that a shot!
×
×
  • Create New...