Jump to content
SAU Community

Recommended Posts

Ok, I *think* I know the answer, but time to check, before I spend $$ etc

R33 '96 Series 2

T3/4 Hibrid Turbo

FMIC

Stainless Ducting

3" high Flow, all the way through

Mines ECU

Adjustable Fuel Reg

Pod

Etc, Etc.

When I'm using the engine to brake, usually when i've been doing quite a few k's at motorway speeds (100-110), I get random pops/almost backfires. Usually only one or two, when slowing down for a roundabout etc.....

It's noticable to me, but not to an uneducated passenger, so they're not too noisy.

I think it's because i'm running rich atm, and am going to be changing ECU & getting a retune done soon (Which should fix it, and a little more power, I hope)

(IIRC, I was running 12.5's on the mix at the last dyno)

Any other thoughts?

Link to comment
https://www.sau.com.au/forums/topic/54658-pops-backfires/
Share on other sites

mine does the same mate ...

just unburnt fuel passing into / through the turbo and igniting in the exhaust ...

when you have LOTS of fuel going through, then you get, ahem, nice flameouts ...

slightly more than a popping noise tho when this happens .... a friends rx-7 in the uk used to shoot flames on each gear change ..

lol

Link to comment
https://www.sau.com.au/forums/topic/54658-pops-backfires/#findComment-1069349
Share on other sites

My GTI-R does it. I love it! It sounds great on gear changes. Mine is caused by two things, free flowing straight through exhaust and rich as tune. Don't worry about it too much. Unless of course it has only just started happening which may indicate a problem.

Richard

Link to comment
https://www.sau.com.au/forums/topic/54658-pops-backfires/#findComment-1069800
Share on other sites

Due to your car running rich, the unburnt fuel when you back off the throttle is left in the chamber, So once your throttle body closes theirs no more air only leaving fuel to hit your nice hot turbo. Which ignites and back fires. no mager dreamer, as lots of skylines do it. You should see what happens when you have a 700hp GT3540 and that fuel hits that a full noise. Its pretty awesome flame about 1m long.

Just make sure your exhaust sticks out far enough from your back bumper, other wise it will melt it eventually.

Link to comment
https://www.sau.com.au/forums/topic/54658-pops-backfires/#findComment-1069991
Share on other sites

thats more a result of a sh|t tune.

my car doesnt pop/backfire or flame and it has no cat

NOPE, don't think so. mine pops away quite happily on occasion as a result of a very free exhaust and nothing to do with my tune which is near on perfect 12:1 AFR's thanks to PFC.

Link to comment
https://www.sau.com.au/forums/topic/54658-pops-backfires/#findComment-1070710
Share on other sites

Interesting leg you're standing on. So you're telling me that my car isn't actually tuned properly and every car in victoria is so therefore they don't do it?

Anyway, lets not start a shitfight. Agree to disagree but I can tell you there ain't nothing wrong with my tune :uh-huh:

Link to comment
https://www.sau.com.au/forums/topic/54658-pops-backfires/#findComment-1070890
Share on other sites

thats more a result of a sh|t tune.

my car doesnt pop/backfire or flame and it has no cat

I think you will find it has absolutely nothing to do with a sh!t tune. If in fact it’s probably a good tune if your car does pop/ blow out flame.

Because if it does then you know you don't run as much of a risk of leaning out your motor and killing it, as compared to no back fire, were you don't have enough fuel into the engine causing it to run lean.

If you watch the Japan drag racing I think you find just about every one of their cars running any were from GTS-T running 11 to GTR running low 8, pop and back fire every gear change. Because they tune them rich, for reliability.

Link to comment
https://www.sau.com.au/forums/topic/54658-pops-backfires/#findComment-1071112
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Try looking at Eibacb/H&R springs Thats what Gary sourced for mine.
    • Hey y'all! I'm curious about how y'all go about widebodying your cars. I noticed that when running a square setup, my front wheels are a bit more tucked in than my rear wheels. Not by much, maybe 5-10mm. This leads me to wonder - when I widebody, should I use narrower front flares and wider rear flares? I found a set of 40mm rear flares that I really like, and was thinking of pairing them with some 18mm front flares, but I don't want the car to look strange. How have others done this? Note, I'm in a sedan. Thanks!
    • And if it was anything other than an auto tranny part, it might be a problem. But seeing as all auto trannies belong in the recycling bin, it's fine.
    • I have an R32 Fenix rad. It is good.
    • All the schemas I can see, indicate your typical setup of ATF 'cooler' (read: heat exchanger) in the bottom radiator tank..ie; https://nissan.epc-data.com/stagea/wgnc34/5413-rb25det/engine/214/ ...but I can prattle on a bit here. These trannies have a thermistor in the sump ~ the TCU reads this and 1. bumps the line pressure up when the ATF is 'cold' and 2. prevents the TC lockup clutch from operating, until the ATF comes up to minimum operating temp (keeps the ATF 'churning' through the TC so it heats up quicker) -- trigger point is around 55C. In these conditions, the engine coolant temperature rises faster than the ATF temperature, and also helps heat the ATF up, which is why it's best to think of the in radiator tank setup as a heat exchanger ; the heat can flow in both directions... ...with these trannies, the 'hot' ATF comes out the front banjo bolt, flows through the cooler/heat exchanger, and returns to the box  via the rear banjo bolt. This gets a mention, due to the wildly different opinions wrt running auto trans fluid coolers ~ do you bypass the in radiator tank altogether, or put the cooler inline with the in radiator tank system...and then, do you put the additional cooler before of after the in radiator tank system?... ....fact is the nominal engine operating temp (roughly 75C), happens to be the ideal temperature for the ATF used in these trannies as well (no surprises there), so for the in radiator tank system to actually 'cool' the ATF, the ATF temp has to be hotter than that...lets say 100C -- you've got 25C of 'excess' heat, (slowly) pumping into the 75C coolant. This part of the equation changes drastically, when you've got 100C ATF flowing through an air cooled radiator ; you can move a lot more excess heat, faster ~ it is possible to cool the ATF 'too much' as it were...(climate matters a lot)... ...in an 'ideal' setup, what you're really trying to control here, is flash heating of the ATF, primarily produced by the TC interface. In a perfect world, wrt auto trans oil cooling, you want a dedicated trans cooler with builtin thermostatic valving - they exist. These should be run inline and before the in radiator tank system ~ when 'cold' the valving bypasses the fin stack, allowing the ATF to flow direct to the in radiator tank heat exchanger, so it works 'as intended' with helping heat the ATF up. When 'hot' (iirc it was 50C threshold), the valving shuts forcing the ATF through the cooler fin stack, and onto the in radiator tank heat exchanger...and you sort of think of it as a 'thermal conditioner' of sorts...ie; if you did cool your ATF down to 65C, the coolant will add a little heat, otherwise it works as intended... ...the 'hot' ATF coming from the front bango bolt, is instantiated from the TC when in use, so all/any flash heated oil, flows to the fluid-to-air cooler first, and because of the greater heat differential, you can get rid of this heat fast. Just how big (BTU/h) this cooler needs to be to effectively dissipate this TC flash heat, is the charm...too many variables to discuss here, but I just wanted to point out the nitty-gritty of automatic trans fluid coolers ~ they're a different beastie to what most ppl think of when considering an 'oil cooler'... /3.5cents   
×
×
  • Create New...