Jump to content
SAU Community

Recommended Posts

R33 Series 1

Stock internals

Stock injectors

Stock intake manifold

No AFM

911T 500 hp fuel pump

Surge tank

Rising Rate EFI Reg

Haltech E6K

Haltech ignition

High flowed Hitachi turbo (bored compressor housing, 56 mm inducer wheel, ball bearing core, steel wheel with extra trim on the hot side)

Front mount intercooler

Heavy duty clutch

Blitz dual SBC

3.5 inch exhaust

12 psi

247 kw

post-25026-1142376433.jpg

-Stock ecu

-12 psi

-Bp Ultimate

-Pod, 3 inch turbo back, dump pipe, Otherwise stock

185rwkw in shootout.

The guy found a dead short in the o2 sensor, so it is diabled for now. idle was a joke, so I had to disable the secondary air valve (or whatever it's called) until i get a new one. Fuel economy went from about 12.8L/100k highway cycle at best to 11.6L/100k towing a trailer a 120kph! not bad at all.

dyno attached

post-20742-1143423396.jpg

Edited by jezzerrr

95' R33, GTS-T, Manual

- 3" Split dump/front & 3.5" HKS Cat Back

- R34 Intercooler

- K&N POD with heat sheild

- Mechanical Boost controller

197.4kw@10 psi at UAS, 11th march 06

196kw@10 psi, AFR=11 at the Hitman, 16th March 06

post-24486-1142855035.jpg

post-24486-1142855059.jpg

As per my sig.

Am I reading psi on the right on this chart reaching 25psi :P .

I thought it was 16psi

R33 2.5

Microtech LT12

3" split dump, back

malpassi fuel reg

Walbro pump

Pod

Fmic

HC_Dyno_050505__Medium_.bmp

Hello from Norway...

RB25DET

Stock block and head, not opened.

Aeromotive fuelpump/regulator,modified rail.

Nismo 740cc injectors, Greddy plenum.

75mm Throttlebody, Electromotive coils.

350x600x100 Intercooler 3"Tubing

Modified HKS manifold, Turbonetics T60*5 old school

HKS W.G., 3"Exhaust, no cat, single muffler.

O.S.Giken twinplate clutch/flyweel.

DTA engine management

353 rwkW/7300rpm(481rwhp)

366 LbFt /5700rpm

21psi peak 4800rpm

18psi @8000 rev.limit

98 ron pumpfuel

Dynapack hub readings

DynoKOKWBoost.jpg

DynoKOTqAFR2.jpg

HPIM1422.jpg

DSC_0249.jpg

Edited by Tex Willer
  • 2 weeks later...

Power Fc

3" Straight Through Stainless Exhaust

Sard Fpr

Walbro Fuel Pump

TurboSmart Type 3 Supersonic B.O.V.

10PSI

Standard Turbo

Standard Intercooler

185.4Kws @Wheels

Not Much UAS Tuned Monday

Just Waiting To Get Cam Gears, Intercooler, Plenum And Gt30r To See Wat I Can Get Then Hoping For 240kws Before Having To Change Injectors!

96 Series 2 R33 GTS-T

stock block

stock turbo

stock ecu

stock intercooler

turbotech boost controller @ 8psi (the one that everyone is buzzing about on these forums!)

3" front/split dump, 3" catco hi flow cat, 3.5" cat back

aftermarket air pod

172kw tuned by CRD.

post-5020-1144591110.jpg

Next is Hybrid GT spec intercooler, and walbro pump (stock pump is lazy). Want to run 12psi after these mods, rekon I could hit 200?

ok i have posted this else where but will put it up here for the sticky.

R33gtst 95

custom FMIC (tube and fin) all pipes are heat repped.

ECU rechiped Nerve Essential stickers all over it.

stock turbo 0.75bar holds boost all the way to 7k

comes on full boost at 2600 but only really makes good power at 5600

hks pod

apexi bleed valve (spikes at .9bar)

apexi catback exhaust (now have split dump, 4" magic cat and splitfire coil packs dyno was before the extra mods)

unknown cams or cam gears

unknown pump

dyno2.JPG

http://home.iprimus.com.au/maddog_wraith/dyno2.JPG

Edited by race_snooze

94 r33 gtst Series 1

Stock Internals,

FMIC Hybrid

Apexi PFC

3.5 inch cat and cat back not turbo back Unknown Cat possibly highflow, but not OEM thats all i know

K&N Pod

Stock Injectors and pump

Splitfire Coil Packs- Best Investment so far of my own

Hybrid Boost Controller, Cheap but effective,

Running Motul 8100

Dyno Tuned in shootout F6 mode, with 95 RON Vortex, forgot to go the Ultimate for tune

178.9 RWKW Tunned to 6-7 psi boost Low boost

High Boost 10 psi, No Readout or tune for this setting,

Tunned at APC Underwood

I would post dyno sheet but no scanner handy

Stock Block and head

Stock injectors

HKS FCON V

HKS VPC

HKS GT3040

HKS 45mm wastegate

HKS Pod filter with No AFM

Tuned length exhaust manifold

Turbo back 3 inch exhause

Greddy Profec B Electronic Boost Controller

ARC FMIC

222kw at the wheels at 0.63bar or 9psi

I was a little stunned at the amount of power for low boost it was running. Ran it twice and got the same results

A set of 550cc injectors would do the car wonders.

Also, car is for sale... just a little plug :P

  • 2 weeks later...

Auto 4WD Stagea

Only mods:

GCG highflow

3 inch split dump/front pipe BTMBL

5 inch catco cat

3 inch stainless fuji catback

GTR FMIC with custom stainless pipes

Pipercross air filter in stock airbox

~11psi

Coilpacks breaking up 5000+ RPM

Peak power at 6800 and still going 157.7awkw

Will update when new coilpacks, poncams, DFA and SITC

1994 GTS-T S1

Power FC

Tomei Poncams (rest stock internals)

Sard 850cc Injectors

FMIC

Sard FPR

GT3540R .82 EXH on high mount

Turbosmart 48mm progate wastegate

Bosch 044

Z32 AFM

BP Ultimate fuel

full exhaust mods from turbo

Pod filter

15psi boost

410.7rwhp (306rwkw)

post-15008-1147076184.jpg

96 Series 2 R33 gts-t

stock block

stock turbo

emanage ultimate

blitz intercooler ( not 100% sure)

HKS boost controller

3" cat back

pod

bov

bosch 040 fuel pump

206.9rwkw @.9bar

turbo blown on monday, after new turbo, garrett 307..something or trust t05? any ideas which way to go? mate who sells trust says much better and extra $1000 on top also. Whos running either and has input? Want asap as need car back to drive to work to make the money to spend on the car to get me to work faster

  • 2 weeks later...
Has someone got a reference dyno sheet of a stock turbo'd engine? That would be good to compare against.

1996 series 2 gts-t

I've got a standard turbo running 1 bar with a power fc that has 290 rwhp

hks intercooler

hks super dragger

malpassi 2:1 regulator

044 fuel pump

96 rb25det

full exhaust - split dump pipe to 3 inch fornt pipe with 3 inch high flow into 3 inch HKS system

apexi pod

hks ssqv

denso 300 l/ph performance fuel pump

sard FPR

hybrid FMIC

apexi avcr (set on .9 to .95 bar)

ngk iridum plugs, synergy 8000 pulp, motul turbo light oil

200rwkw

Edited by ICER33

95 r33 series 1

Standard turbo @ 11psi (turbotech boost controller)

Standard ECU (no piggy back)

Hybrid front mount intercooler

Split dump

3" front pipe

3" X-force cat

3.5" X-force cat back

Pod

New O2 sensor and NGK copper plugs

273.6hp (204rwkw)

post-27937-1148514422.jpg

Edited by mad082

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yep, that was one of the things we learned fast in the past with our MX5. When you drive with the top down, you are effectively standing out in the sun, 100% of the time, and not getting in any shade (because roads aren't shaded generally!). Just like standing out in the middle of a field on a sunny 27C day is a bit of a bad plan, so is sitting in a MX5 without sun protection.
    • I also just ordered some Frankenstein bolts and side mounts to fit a hard top Just in case I do find one, basically so it doesn't need to be fixed to the car with only the front latch.......and then gaffa tape to keep it in place for the RTN journey from wherever I get it
    • If your temps are fine now, you probably won't have any issues with where your vents are as they don't look right up at the windscreens high pressure area, so any differences when giving it the beans for extended happy laps would be minimal, but, they should vent heaps when stuck in traffic  Much like how that reverse cowl on my SS let "visible" heat out when stationary, but, because it was basically at the windscreen my coolant temps on the Hwy actually raised because air was being fed into it at speed (110kph), to only come back down to around 90° when I got off the Hwy And your 100% correct about the NC currently not needing vents, but, if I was to add a turbo, and a oil cooler and intercooler in front of the condenserand radiator, and then take it to the track???? It is apparently a recommend requirement if I don't want to worry about coolant or oil temp issues, but, any of the above are possible scenarios, over time As it sits now, with the triple pass radiator and stock air conditioning system, I have absolutely no issues with either temps or air conditioning efficiency, I've been basically daily driving thie car for the last month, both on the Hwy, and peak hour, bumper to bumper traffic, but, that's pretty much expected from basically a standard engine  Talking about no issues daily driving, it was 39° the other day and I was sitting in bumper to bumper traffic on the M5 and then M7, with the top down, and with the air conditioning blowing nice cold air on my feet, balls, and face, well, there was one issue, my head and arms got pretty sun burnt Note to self: leave a hat and sunscreen in the car for such days 🤣
    • I would agree, unless you need something specific to the HV motor/battery side repaired or investigated, any mechanic will be able to perform normal services, but if you prefer, maybe look for a mechanic who regularly services/repairs Nissans, the VQ engines are pretty common in the Nissan lineup.  Sorry, I can't make any suggestions, I don't live in Vic.
    • Some of them keep working fine. 9 out of 10 of them end up causing an absolute misery bleeding the system and get thrown on the workshop floor in a tantrum and never thought about again because they were never really needed and just added crap to the car that we could have done without. Same-same with HICAS, A-LSD, and various other stupidities that over eager 10x engineers thought we had to have.
×
×
  • Create New...