XF Throttle body on sr20det TPS wont work running wolf3d V4

[OutZero]

I just finshed installing a custom plenum and XF throttle body onto my car, i wired up the TPS to the WOLF3D, i also have a avcr i got the hand controller of the wolf and put the AVCR onto the throttle screen, and depending how i had it wired up it normaly sat on 22% when my foot was off the throttle and then like 60% once i put my foot to the floor, and the AVCR went from like 45% - %60 they both where all over the place, they use to be pretty much spot on with my old TPS, i know i will have to edit the wolf to get it to be right tho my AVCR is always going to be out? is there any other TPS that will fit onto the XF throttle body i heard people using WRX ones and stuff like that? has anyone has any problems like this before if so reply here or email me at [email protected]

here are pic's of the setup

www.osturboparts.com/plenum

Thanks

[OFENSV]

you can calibrate the wolf but not to sure about the AVCR

[OutZero]

any idea how to calibrate it?

[OFENSV]

the wolf, you hold clear for 5 seconds, scoll down to tps then calibrate. push right to set then push the throtle to full throtle and release and its set