Jump to content
SAU Community

Recommended Posts

Hi all - anyone have any ideas where a CD stacker could be installed in the stag?

Doesn't look like there is enough room under the front seats and sticking it under the passenger side glove box would severely restrict leg room... :P

Any ideas, thoughts, suggestions, solutions???

BTW when I looked under the front seats I noticed that both driver and passenger have wires attached - would this imply the seats are heated?

Cheers ;)

Link to comment
https://www.sau.com.au/forums/topic/58490-cd-stacker-placement/
Share on other sites

  • 4 weeks later...

Wow, I like the AMP mounted inside the spare wheel bit !! I might do that with the amp for the sub ! I wonder how it goes with heat and ventilation ?

I just relocated my stacker to that pocket on the left hand side of the car (it was just bolted to the floor on the left hand side.

I mounted it as low as I could in that pocket, so the top of the stacker is at the bottom of the pocket, so I can still use all the space that the pocket had before. I just hope the Octane booster bottle doesn't leak into the stacker !!!

J

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Hey lads just finished tidying up a gtr a bought. Originally from Sydney now living in New Zealand 
    • Hi Guys, Looking for this piece if anyone can help out.   https://tfaspeed.com/products/nissan-skyline-r33-gtr-rear-trunk-finsher-panel
    • How did you go with your problem? End up fixing it. Have a y34 aswell vq30det
    • But if I smoke test 5th cylinder it’s all ok, no leaks  when I try with 2nd it’s leaking exhaust and intake, it doesn’t come from oil dip stick.    so maybe when car was running poorly, rich or sth. Spark plugs were black and covered in charcoal or sth lookalike. could potential contamination make valves not seal properly? is there also a possibility that rb’s don’t have equal performing cooling passages  meaning back of the engine will be hotter than front. Can this cause improper wear if engine was running under load for short time? Or carbon build up could just burnt from 4-6 and is still on 1-3?   I out of my head like really. Timing is as manual crank-exhaust 47, exhaust-intake 38 at this point I thinking about give it a try and make another 500-1000km and check if anything change, if not I will most likely disassemble engine head /or whole engine and send it back to rebuild. It’s killing me     
    • Thanks Duncan, I don't have a GTR these days mate. Gone soft..
×
×
  • Create New...