Jump to content
SAU Community

My birthday prezzie to myself..


PranK
 Share

Recommended Posts

Very nice any chance you can tell me where from and how much as I will be doing the exhaust down the track and if I can purchase an off the shelf item it would be better than getting one made up. Also I wish to get a set of clear side indicator and don't know where to look for such items.

Cheers ICE

Link to comment
Share on other sites

Hey Shane,

The clear sides are the same as the R34 GTR, nismo part # RNC40.

The exhaust was from Nengun (the only person who gets my money for car parts online). With shipping and everything, it ended up being about $900 to my door. Not bad i reckon as local made exhausts in full stainless will cost you that much without the knowledge that TRUST has for such cars.

Hope that helps. Cant wait to fit it. :P :headbang:

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Yes, I've been thinking about how to fabricate something. Either how OP did it with an alloy sheet or more complicated. Because of the CD shifter protrusion I think I will need to build a raised aluminum box to clear, then I would reutilize the same OE seal just shifted back. When I went on my test drive I popped open the EWG and exhaust just filled the cabin, so it will need to be closed up.
    • Car is struggling to rev from idle when you accelerate normally to spirited, But it will get past 1000ish rpm if you feather it, and then is fine so long as the revs don’t drop again. Idles fine. Plugs come out wet as after a few min.  Things changed are: CAS, ARM and fuel reg from a engine that was confirmed working 2 years ago Injectors have been reconditioned  ECU has no codes Where to from here? Video of the issue can be seen here  
    • I am trying to get an aftermarket exhaust and browsing the threads for opinions. But most of them are almost over 10 years old. Just tryna look and see what exhaust setups people are using nowadays and what are yall opinions on them. Really want to find one that sounds nice and not as quiet as the stock but does not scream rice.  
    • Approx 1m long, chrome moly, hardy splicer unis. Didn’t measure the diameter. The shop that built it also builds the shafts for b2r, jem, maatouks, etc and built the shaft to the same specs as their cars that’s are running 7 and 8 second passes!! Which say to me that it can handle some big mph 
    • You can't stall an engine at high speed.
×
×
  • Create New...