Jump to content
SAU Community

Recommended Posts

  • Replies 52
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

NOS on turbo cars is the best antilag you can get but setup in 2 stages,Less gas as boost rises. Ive used it on turbo automatic cars to aid launching on low stall converters.

Anyone seen the green ZD fairlane (1971) that got banned a few street meets ago?250rwhp then hit the gas and it finds 490rwhp and run 10s on basic old suspension.

You could lift an n/a RB25 to close to 300rwhp if setup right as we have even done this in crappy red motor holdens so an RB has to be able to. We ran Tango1 with NOS last year on cheap cast pistons.

Link to comment
https://www.sau.com.au/forums/topic/60796-nitrous/page/2/#findComment-1152957
Share on other sites

Mirkz , as some of the guys have said , a propper NOS system is fully independant of any ecu . It's just a matter of jetting the fuel nozzle to suit the Nos nozzle your using & keeping the pressure up in the nos bottle (Bottle warmer :))

50 to 100rwhp gain on your stock gutted 25 should be readilly achievable.

Link to comment
https://www.sau.com.au/forums/topic/60796-nitrous/page/2/#findComment-1153382
Share on other sites

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Some of them keep working fine. 9 out of 10 of them end up causing an absolute misery bleeding the system and get thrown on the workshop floor in a tantrum and never thought about again because they were never really needed and just added crap to the car that we could have done without. Same-same with HICAS, A-LSD, and various other stupidities that over eager 10x engineers thought we had to have.
    • Not required but appreciated. Super Coppermix Twin even the non-competition model feels like the pedal is noticeably heavier than stock which was pretty well judged IMO. I'll be swapping in the Nismo operating cylinder soon to see how that feels.  Personally I haven't felt anything that justifies replacing the damping loop, at least compared to more modern stuff where the clutch delay valve is actually quite noticeable.
    • He made that comment in my thread - In my case the vents ARE to lower engine heat, when the car is not moving, which is the only scenario I have heat problems with the aircon on, sitting in traffic, on 40C+ days. I can't imagine a scenario that this NC needs any at this point in time. I do not know if it will actually make my cooling when the car is MOVING worse, and I sincerely hope that won't be the case. If it does, well, um, f**k.
    • Nice, thanks. Thats why I was asking, there'd been a fair bit of discussion in the E90 world about vents and where it makes sense to put one (ie, over the filters is not great as that is inline or slightly behind the struts and in higher pressure area). I struggle with air flow and pressures. It sill weirds me out that a radiator in the boot can work. 
    • Neither really Vents, when located in the right place, will lower the engine bay "pressure", as air has a path to escape, thus lowering the engine bay pressure, thus.....improving the efficiency on the coolant stack (read: IC, condenser, radiator) This is why the Blits vented bonnet on my 33 worked so well, the vent was in the front 1/3 of the bonnet, which put it right after the radiator  If the vents are to far back toward the windscreen, which is a high pressure zone, it can actually force air into the engine bay, causing higher pressure and effectively loosing efficiency on the cooling stack, like the fab of raising the rear of the bonnet, which does allow heat to escape, but only when the car isn't moving  There's heaps of cool "fluid dynamics" info out there, but, I'll attach a video of a 'Merican joint that focuses on "Miatas" as I found it when looking into vents for mine, they explain it way better than me  
×
×
  • Create New...