Jump to content
SAU Community

Recommended Posts

heya,

this may be a dumb question but,

las nite was the firstd time i took my r33 for a decent trip. now when highway driving my HICAS light came on and wouldnt go out until i had turned the car off and started again. is this surposed to happen? if so what the heck does it mean?

cheers!

matty

Link to comment
https://www.sau.com.au/forums/topic/62126-hicas-light-turning-on/
Share on other sites

thanks dude!

I will take a closer look but I have a funny feeling it isnt there....the car is still getting the aircon sorted out... Im sure I am going to get murdered for the 134 conversion and the second hand compressor.... :)

could it be somewhere else? its 11/92 R32 GTR......

I never really noticed or felt the ATTESA working on mine. My bro thinks its what makes it squirm around in the wet when driving over standing water, but I keep telling him that its aquaplaning cause the rear tyres are too worn :roll:

Well they didn't find the prolem today, they did work out that it comes on after about 4km of driving. But they couldn't get the HICAS ECU to do a diagnostic check, so it might be the ECU. It's going back in, in acouple of weeks, and it'll stay there till it's fixed this time.

4 wheel steer @ high speed and only up to 1.4 degrees i believe

Nope, not just high speeds. While parked, get a mate to yank your cars steering wheel to full lock (left or right) and watch the back wheels.

Jordan: You wouldn't experience ATTESA unless you own a GT-R or GTS-4. :D

sav man: have you tried getting in to HICAS diagnostic mode yourself? Its not all that hard: instructions are in the FAQ forum. Actual understanding the codes is a bit difficult though :rofl:

LW.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I don’t really have any ideas how to set the timing on the CAS 😂, sounds like the top, sounds like it maybe misfiring as well as ticking,  got the box sorted 😌, must of been a air bubble on the clutch side
    • Use a 2' length of hose (that's 2 foot, not 2 inches) as a stethoscope to localise the source of the ticking. From cam covers? From exhaust or turbo manifold gasket? From injectors? From lower down in the engine? Etc. Use a timing light to set the timing. Put Redline Lightweight Shockproof in the box. It's not the very best thing for the box, but it will take a box that refuses to engage a gear with other oil, and make it engage a gear. I had to put it in when I installed the R33 box I have in my car. It would not select ANY gear when running. Smurf jizz made it work. That was >10 years ago and I still use it. I'm stuck with it now. Failing that - rebuild the box.
    • Well done Duncan. The fuel tank bulkhead lid is also in great condition (some of mine were stuffed). These are now out of production and good ones like that are becoming hard to come by.
    • Wow that's a steal, you've done well there. 
    • Exterior LEDs R34 2Dr R34 4Dr Position Lamp T10 T10 Winker front T20S T20S side T10 T10 rear T20S S25S150 Anti-hyfla relay TYPE3 TYPE3 tail T10 T20W Stop Lamps T20W T20W High Mount T16 T16 back T16 T20S number T10 T10 trunk T10 T10 Interior LED Item No.     Map Lamp BA9S single-sided     Room Lamps T10×31     Trunk Lamp T10     meter Early T6.5 pedestal     final T6.5 pedestal     NISMO T6.5 pedestal     Liquid crystal section T6.5 pedestal     Winker T6.5 pedestal     High Beam T6.5 pedestal     3 SERIES METER Early T6.5 pedestal     final T6.5 pedestal     NISMO T6.5 pedestal     air conditioner Early Liquid Crystal T3     Late LCD T4.2 Short     button T4.2 Middle     Hazard SW T3 Pedestal Short     Keyring T5     Cigar Socket T5
×
×
  • Create New...