Jump to content
SAU Community

Recommended Posts

So far i just know that the R32 RB25de and R33 RB25de came with the 5 speed auto. I'm not sure if all of them did.

My HCR32 has a 5 speed auto.

It has 3 gear selections on the shifter and then 2 other gears on overdrive.

The overdrive sucks because when I'm driving Miss Daisy in the back and select OD after 80kmh, both 4th & 5th gear shift within a couple of seconds and the next thing I know I'm doing 80kmh with the engine turning at 1500rpm - needless to say it's pretty bloody gutless down there in that rev range. But when I'm on her she'll swap into 4th at 150kmh and 5th at 190kmh.

My only real bugbear is the inability to select 4th and 5th at will, which is why I'm in the middle of procuring everything for my manual conversion, no more auto for me.

I saw a five speed in a non turbo rb20de R33.... 4 door.....

I thought it was very strange as the dash in the 33 has the gear selection lights it had 1-4 then drive... a normal auto r33 had 1-3 then drive...

I dont know where youd get that info other than nissan japan... I have only ever seen one myself and i was confussed... I spoke to the guys in our auto devision and they had never seen one nor did they have any tech info on this box....

Yeah putting a manual box in a standard auot is a good thing...

I did it in my old GTSX.... The diff ration is taller and makes for a faster acc but lower top speed... But top speed is not important at QLD raceway nor on the strip as you will never reach red line top gear..... So yes this is a great idea....

Nissan had the 5-speed auto transmission designated RE5R01A, it's sister to the 4-speed, the RE4R01A and was used in both the Skyline series and the 1999 Q45 4.1 V8 Infinity, although there are other vehicles, I can't remember exactly which ones.

The manual coversion is going to be a wait and see as the gearbox I have coming is a Nismo close ratio, so the diff ratio may be a bit extreme for the box, should be fun for a while though!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • From the pictures I have when doing the job the flywheel is the same diameter, I don't think they're playing weird tricks like putting weights at the outer diameter to increase flywheel inertia or anything like that. The OEM flywheel is definitely heavier, but it's not a huge difference. Quoted weight savings of the clutch is 2 kg so I can't imagine the flywheel being lighter than ~7 kg. Kind of regret not weighing it before the clutch went into the car but as far as driveability goes I have no complaints.
    • HKS trigger kit should be very easy to integrate with a Link. It's a 36-2 crank trigger. Hard part is finding the motivation to take off the timing belt and everything on the front of the engine to install it. You also need to cut out a hole in the oil pump housing so the sensor can read the trigger wheel. Changing out the cam sensor for a 24 tooth setup is probably good enough but as others have mentioned depending on what underlying assumptions are changed it becomes more of a problem. Reading the crank state off of the cam is an abstraction that works in the general case, but if you have an edge case it makes less and less sense. There is a GTX2860 gen 2 that can take a compact 5 bolt housing so it's direct bolt on but I'm not 100% sure of what's involved. Peak compressor efficiency drops off a bit on these turbos vs -5s, 77% vs 73% but you get way, way wider region of operation. The -5s have a really strange surge line in their compressor map that is all over the place. If you think the hot side on the -5s aren't open enough you can try the Tomei T550B turbos which a local tuner seems to be happy with:
    • i need a complete tail light for my R33 GTR if you have please let me know.
    • I need a great maintenance workshop around Idaho, if you know one please let me know..
    • Hello friends, i have a good friend in Canada that looking for a good condition 1993 GTR around him please if one or know someone around you that is willing to let it go please let me know so that i can inform him.....Thanks
×
×
  • Create New...