Jump to content
SAU Community

Recommended Posts

  • 3 weeks later...

dammit i need to spend more time in my own forum...

Yes it will fit and although may not be necessary, i would fit the sump and oil pickup from the original engine just to be sure....as far as i know th l28 is taller than the l20 and the diesel one are taller again(as said above) but they will all bolt in......hmm turbo diesel r30? lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Has anyone used the billet half-moons that are available to replace the rubber ones at the back of RB cam covers ?  Going to change out my cam cover seals as they are weeping oil and its now driving me nuts. Any advantage to be found ?
    • My muffler was fully customised to suit the car. He mailed me the end caps, I marked up the pipe locations (4 pipes in a single muffler) and he sent it back all welded. Certainly more expensive than a mass produced generic size, but that's hardly surprising. My R32 Exhaust has a Magnaflow muffler in it, if I need generic mufflers then they're usually a safe bet. I've got the Vibrant clamps on the intercooler pipes, just because they're nicer to use than the bolt together ones and not as expensive as a real Wiggins clamp.
    • Yeah. Nah. A grain of sand will take out a ceramic turbine that is doing 100000rpm.
    • Yes, it was checked with the roller rockers installed using a LS7 lifter that had been converted to a solid lifter with a dummy spring at 0 lash with a stock length pushrod. With the Johnson lifters longer pushrods were needed which are now 7.700" and 110 wall. Long thiccbois. People much more knowledgeable than I am are doing the measuring! 
    • Well... New things have arrived... And now I need to really dig into the design of the power steering reservoir.    
×
×
  • Create New...