Jump to content
SAU Community

Recommended Posts

After the instakllation of the GT-RS turbo i have noticed some pinging (the dash warning light is coming up when giving it a bit). I took it back for a re-tune, dropped the boost back to 1.2 bar and took the timing back a few degrees and richened the mixtures to i think 12.5 and there is still pinging. I raced at the creek last night and it pinged in 2nd gear at 4500 rpm to redline then the other gears it was fine. The tuner said it is that the engine is getting to hot?? any ideas?

Link to comment
https://www.sau.com.au/forums/topic/65677-pinging/
Share on other sites

I have done everything regarding fuel system. injectors, pumps 044 and standard, sard fuel reg, (filters, plugs, all oils, and gaskets were replaced when turbo was fitted). Have a Power FC for management. Dont have cams, plenum or anything like that. It does not ping when i put the boost to 14psi but when it goes up from that it begins, also you cant hear the pinging so its not bad at all just the slightest knock.

Link to comment
https://www.sau.com.au/forums/topic/65677-pinging/#findComment-1227476
Share on other sites

Not having a HC doesn't help much !

What fuel are you running, If you'r running down the strip i'd use BP ultimate + Nulon Octane booster, this stop detination :( - Could be a bad batch of fuel.

Other wise its down to the tune, you said 2nd gear... get you tuner to do the map tracer for second gear, find the detination points and pull 1º - 2º of timing & add more fuel in thoes load points.

:D

Jun

Link to comment
https://www.sau.com.au/forums/topic/65677-pinging/#findComment-1228469
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I purchased some (used but new to me) Yokohama A050 Mediums to try out for the first time and fitted them up to one of my sets of Rays TE Fortesst's. Sizes are 235/45R17 front and 255/40R17 rear. They are very chonky compared to the same sized AD09 on the same sized rim. Some fiddling will be needed to make them fit. How much camber do these like as a general rule? I imagine more than the rear camber of -1.5' I typically run. So my plan is to target -3.8 front and -2 rear
    • If you want to test it under temperature, I think you should enter the One Raceway day tomorrow with Duncan!
    • That looks great Mark!
    • Yeah yeah, the oven did get a good clean after the "baking"...LOL In other, wrinkle black painted stuff news, expansion tank and PS reservoir all fitted up and tested at temp Much nicer than the yellow stained plastics   
    • You now say stumble, but you said cut out before. Will it slow rev through the cut/stumble? What gap were your spark plugs set to when you them in?
×
×
  • Create New...