Jump to content
SAU Community

Recommended Posts

Spooks

Yes thats true for most standard ecu - wrx is no different.

Just with the link even when tuned well - it will still run alittle rich - its like a built in insurance policy with the link.

you'll see if you gt a link ;0>

  • Replies 66
  • Created
  • Last Reply

Top Posters In This Topic

Ok, if your going to make a bold statement like that, you need to suggest/list some factual information here.

ok. A few important things for me are

1) A good tuner... which leads into 2...

2) A good tuner that wont charge you an arm and a leg

and for one thing, in Vic that is very hard to find when compared to a PFC or a Wolf.

I dare say that applies to most other states in this fine country

i NEVER had this issue with my LINK when it was tuned properly.

One thing that rings true though is that my car chews through fuel, and runs extremely rich.

You've even said it runs hell rich.

i wouldnt call that a good tune. A good tune wont ever run lean BTW

also.. Does the link use the knock sensor input???

I am currently running a Link Plus in my car and i am very happy with it. I have also had a Power FC and if i had to choose between the two i would choose the Link Plus anyday of the week. I previously had too many problems with AFM's etc and decided to change to Link and haven't looked back the only ECU i would replace it with would be an Autronic or Motec but obviously they are much more expensive.

Anyone who has doubts - please look at the link a pasted on page 1 and look at the lack of load points, lack of fuctionality, etc the link has compared to a better ecu.

Yes the fact that the link doesnt use the AFM is great - and as i said my Link was OK - but just look at the simple facts and you'll see that its lacking badly.

Dan

Does the Link (and all the other ECU's that suffer poor fuel economy) have Closed loop running?

It was my understanding that ECU's that dont do this arnt legal as they dont comply with the ADR's. On the back of the Microtech LT1200(?) it says in small print "For racing use only" because of this.

OH dear, another "XXXX ecu versus Power FC" thread......

This is how I see it.....

a lot of the NZ guys use LINK ecus

That's because they are made in NZ

I previously had too many problems with AFM's etc and decided to change to Link
So you had problems with a standard Nissan part and it was the Power FC's fault. More likely yours for not servicing your AFM's properly.

At least you could easily get a replacement, wait until a MAP sensor fails and you get

AVO have no more map sensors, and they dont know when they will be getting anymore... so this is stressing me out big time.
i guess the wrx link plugin is similar to the gtslink
Ahh no, the WRX is a 4 cylinder and the GTST is a 6 cylinder.
for about 800/900 bucks seand hand its OK....
So they depreciate (loose their value) pretty quickly, I wonder why? At $1100 new, Power FC's seem to hold their value pretty well, I wonder why?
i cant expect a car with 300+rwhp to be decent on fuel.
How about 9.4 litres per hundred kilometres from Sydney to Wakfield Park and back (400 k's). And it has a lot more than 300 rwhp. That will save you the $200 price difference pretty quickly.
the car would smoothly decellaratedown in revs and speed with suck utter smoothness
You don't have to tune that with a Power FC, it comes standard in the base maps. That will save you more than the $200 difference in price in extra tuning costs.
good luck with PowerFC and it working from just being plugged in
Must be the way I plug them in, I'm up to ~15 Power FC's and not one car has failed to start first turn of the key and then be driven without issue to the dyno shop for a tune. Cars with the usual mods (exhaust, filter, boost up) drive better than standard most times. I must just be lucky, huh?
link is better then a few of the other choices on the market
I have compared a Link side by side with a Microtec, Haltec and Wolf and I can't see any demonstrable superiorities. As for Power FC, Motec, Electromotive and Autronic .....well not even close.

The bottom line, if you want your car to drive as "nice" as it did when standard and not cost an arm and leg to buy install, and tune, then there is only one choice in my opinion. The Power FC is unmatched in all those areas, it's the best all round ECU for a Skyline.

:rofl:

OH dear, another "XXXX ecu versus Power FC" thread......

it wasnt supposed to be

ive been told that powerfc wont work on my setup, so im investigating alternatives

was just suprised at how little information there was on links on this forum

thanks for you input anyway sydney kid

imacul8, the link plus has all the features you claim it doesn't including temp correction.. does the power fc? runs the std knock sensor also. The ecu comparison link you posted up fails to list most of the links features...

you also fail to mention how many countless hours the holinger equipped car you mention spent on the dyno at west racing?

I agree its far from the best ecu on the market but it does a good job in mine and countless other cars and for the dollars you can't complain.

Nismoid your initial comment on the subject is laughable, shit if everyone on the forum isnt using it, it must be crap.. ? Well done

How about 9.4 litres per hundred kilometres from Sydney to Wakfield Park and back (400 k's).  And it has a lot more than 300 rwhp.   That will save you the $200 price difference pretty quickly.

haha Douche,

Fcuk highway kilometres. I was talking CITY driving, because thats where it fcuks you the hardest.

Highway my fuel consumption is no problems.

DCIEVE

I also fogot to mention that a certain holiger equiped car spent hours being retuned at another perth wokshop.

Agreed tuning is the key.

But more load points (both ignition and fuel) allows for a smoother finer tune.

haha Douche,

Fcuk highway kilometres.  I was talking CITY driving, because thats where it fcuks you the hardest.

Highway my fuel consumption is no problems.

Obviously you don't live in Sydney, there is an hour of traffic to get to the highway.:)

imacul8, the link plus has all the features you claim it doesn't including temp correction.. does the power fc?  

The Power FC has tables for;

Water temp injection correction

Air temp injection correction

Air temp boost correction (if you have the Boost Control Kit)

Ignition water temp correction

Ignition air temp correction

Ignition boost correction

Battery voltage injection correction

Battery voltage ignition correction

And it flashes the standard dash warning light when;

Injector duration exceeds your selected value

Knock exceeds your selected value

Airflow exceeds your selected value

I agree its far from the best ecu on the market but it does a good job in mine and countless other cars and for the dollars you can't complain.  

I'm sorry but I CAN COMPLAIN, if I add it all up the Link actually costs more. It takes longer to install, it's not really plug and play, it doesn't have the quality support maps loaded and correction tables preset, the tuning is far more difficult....Someone has to pay for this additional labour, and that means you.

ive been told that powerfc wont work on my setup, so im investigating alternatives
If the Power FC "won't work" (whatever that means), then the Link sure as hell won't.

I have seen Power FC's running cars with 1100+ bhp, so obviously power isn't the problem. The only issue I can think of is auto transmission, and I can assure you that the Link won't run the auto much worse than the Power FC won't.

So post up what it is that you have been told the Power FC won't do. I am sure someone on here will be able to tell you how to do it.

:)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • And also there were for sale scams and the like. For sale posts need piccies, and not having piccies makes it harder to do a driveby scam.
    • And I forgot to add my *** footnote to the above post, which was that the pipework mods would be even more significant than what had to be done for the highflow. So just add that onto the list. Pipework mods are no killer, just made the tasklist longer at a time when extra tasks were not welcome.
    • I mean he could post them to imgur or the like and create a link. But yeah, spam bots absolutely will post pictures in their first posts.
    • Ah ok, reason I asked was for the sake of not having to upgrade everything if the turbo couldn't be capped.
    • pffft! My alignments are starting to take 3-4 weeks each. Bugger overnight - that would be a dream! Overnight is when I leave it on stands with the rear suspension in pieces, hoping I can remember where I was at when I come back to it. I have to set the car up on a level surface so I can get decent camber measurements, then try to set the RUCAs to the right length to get that right. Then I have to put the car somewhere else where I have enough room to set up the bumpsteer gauge (laser, paper, mirror), so I can dial out that. Then I need to go measure camber again because changing the tension arm length affects that also. Then I need to measure toe, and I can't do that to my own satisfaction at home, so I have to put it on an actual aligner. Then I have to go back and fix the camber again, and if that took more than a half a turn, decide if I want to set up the bumpsteer measurements again. I previously had the bumpsteer almost completely banished and then I started changing things again! And that's only the rear end. Not even gotten to talking about the front yet. And this has been going on in the context of me discovering a seized bolt in the LHR FUCA bush at the upright, hence needing total disassembly to replace that bush and the others that were not far away from the same outcome, replacing sphericals in the front end and making a mistake that resulted in needing to do it again, which is only half done right now. It's a selfmade nightmare. Only have self to blame, etc etc. But regardless, I am so complelely unable to utilise the services of a normal wheel aligner that I have no choice. I haven't found a shop in my city that does "race" alignments - and by that I don't mean I want my car to be set up for racing, but the set of adjustments that I have available and that need to be used to do the alignment are the same as you'd find on a race car. I haven't looked everywhere, but there doesn't appear to be the equivalent of the motorsport focused shops that are present in Sydney and Melbourne. And such an alignment would cost $300, and you only want to do it once in a while, and you don't want to find out that you have to replace bushes and bearings and such while you are spending that $300 so you have to come back and spend it again a week later. So I stay living in my self made nightmare for the moment.  
×
×
  • Create New...