Jump to content
SAU Community

Recommended Posts

Hey guys..

I have a quick question for you. Just got my GTR a couple of months ago and i'm trying to sort out a problem with idle - when you drive the car and take your foot off the accelerator, clutch in, revs drop to 0.

I have fixed a few problems already: New o2 sensors, broken wire from rear AFM, lubricated all throttle linkages (these were sticking! scary!)

One thing that I have noticed is that when the throttle is completely closed there is a ~1mm gap between the throttle stopper screw and the throttle mechanism. This means the throttle butterflies are closed 100% when not accelerating.

Is this correct for an RB26, i know the AAC valve bleeds air past the throttle bodies to regulate idle speed, but is a small throttle opening still required?

Can anyone help..

Thanks,

-Patrick

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Like I said, "black magic" LOL In the end,  it is what it is, and hopefully, what this here knuckle head has done is an improvement and not a hindrance Not that I actually notice any negatives now, or that I will get any seat of the pants benefits when all is said and done, but best practice says I shouldn't be pulling intake air from the hot engine bay  Famous last words: I cannot see it being any worse than what it is at the moment 馃
    • If the gases flowing in those two tracts had the same properties, you could maybe use such broscience. But the exhaust has a different composition, different normal density, different actual density (because of different normal density, and mostly because of the massively higher temperature), and different viscosity (again because of much higher temperature). Consequently, all of the fluid dynamics parameters that matter, that you calculate from these inputs, such as the Reynolds number, friction factors (for wall friction) and so on, are all incomparable.
    • And we shall have to presume that Canada is the same?
    • In the US almost everything is E10. It can't exceed 10% by much or fuel systems have trouble adapting. At the same time because MTBE, MMT, and TEL are all banned they need as much ethanol in it as possible to boost octane.
    • I was mostly jesting. In my experience (and probably only my experience) the R34 GTT physical airbox space is actually too small to flow the amount of power it wanted. By sealing the box, I made it so it could only be fed by the ducts themselves. So you can seal it up and get nice cold air which IS good, but at a certain crossover point: More Hot Air > Less Cold Air I don't think you're at this point. In my case merely ducting the hot air intake with a very focused set of ducts counteracts the fact it's in a V8 engine bay. More cold air obviously best. The solution looks great.
  • Create New...