Jump to content
SAU Community

Recommended Posts

hey,

ive got an r32 gtst, only mods are a blitz filter and GAB suspension. it runs real sluggish until about 4000 wen the boost kicks in.

my bro has a r32 gtst as well, same mods pretty much, however his car seems to push more from the start.

anyone know wat the problem could be?

is anyone else experiencing this?

Link to comment
https://www.sau.com.au/forums/topic/68928-sluggish/
Share on other sites

maybe he had a bigger exhaust + more boost?

try giving a few more details?

actually my car has the better exhaust and is also running a little higher boost.

i think it might have something to do with my air flow meter or the levels. the ***n thing conked out today. it just started stalling wen in gear, and wen idling it was going up and down between 1000 and 2000.

the small hose up the back snapped off, the RACV guy ripped the broken end off and pushed wat was left of the hose back on.

it ran well, until about 20 minutes later and it conked out agian. i checked that hose and it was on fine. has anyone else experienced this? how do u fix it? how much will it cost me?

Link to comment
https://www.sau.com.au/forums/topic/68928-sluggish/#findComment-1278679
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...