Jump to content
SAU Community

Recommended Posts

Anyone know how many points you lose if you get caught in a bus lane? would you even lose points?!?!

also, how long are you allowed in a bus lane? say if you were turning left at the next intersection/side street/etc, how long can you drive in the bus lane before you get to the point you turn off?!!?

thanks!

Link to comment
https://www.sau.com.au/forums/topic/69424-bus-lane/
Share on other sites

f you are fined for driving in a Bus Lane you will incur 3 demerit

points.

Bus lanes are for buses, but also can be used by taxis, hire cars,

vehicles operated by or under direction of the RTA, bicycles and

motorcycles. Other vehicles may only enter a bus lane 100 meters

before turning.

Link to comment
https://www.sau.com.au/forums/topic/69424-bus-lane/#findComment-1288549
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Just a follow-up on this topic. From what I can tell so far the rusty residue on the engine block might be unrelated to a coolant leak or maybe just older than anticipated. After driving it from the winter garage to my friend's garage I could not see any new traces of coolant leaking there, but I will test this properly once I was able to fully warm up the car and drive it for a bit. I think I can agree that the whole porous engine block stuff is kind of nonsense, but there is just a silly amount of true, false and half-true information on anything Skyline-related on the internet.
    • hrmmm , not mine , easter plans to pull engine not happening     
    • I removed the IACV, cleaned it and reinstalled.  I found a video on youtube that helped with the whole process, the guy then said the idle needed to be set, so the process was to get the vehicle up to operating temperature, unplug the TPS, set the idle screw in the IACV so the RPMs were around 600, then plug the TPS back in.  After I reinstalled the IACV, the car started (because, it was a cold start), once it warmed up, the car died, I adjusted the idle screw to see if that helped anything, it did not, I had to wait about 3-5 minutes, then the car would start back up. Only to shortly cut out, and only crank.  I loosened the TPS to see if adjusting that would do anything, and when I would rotate the sensor clockwise, there was a humming noise, but it would go away when I got the sensor in the horizontal position.  It only made the hum noise with the key on.  What do you guys think? 20250414_172604.mp4
    • Quick update.  The engine grounding strap was replaced, the engine is now happily running.  Tested the voltage drop before replacing the strap, was about 1.2ish volts down between engine to battery, chassis to battery. With the new grounding strap, pretty much no voltage drop at all. 
×
×
  • Create New...