Jump to content
SAU Community

Recommended Posts

Originally posted by meggala

and you need to change 2 diffs not one.

look for mods else where

Do you know what happen if I convert to manual n did not change my auto diff to a proper manual diff?

Is there any difference between R33 diff from cars with ABS and cars without ABS?

Link to comment
https://www.sau.com.au/forums/topic/7400-better-ratio-diff/#findComment-108777
Share on other sites

Thx for the info Meggala... I can then keep my diff, no point spending $$ on a manual diff then. That would not throw my

speedo accuracy away, isn't it??? Cause speed sensor is

not taken from the rear wheels?

MrMayhem, if the ABS sensor IS on the nose of the diff, then I might as well keep my diff as sourcing a 2nd hand manual diff I might end up getting a non ABS one. But I think ABS sensor should be on the 4 wheels, coz on the diff doesn't make sense to me, as a good ABS system should be able to apply different brake pressure to different wheels depending which one is locking.

Link to comment
https://www.sau.com.au/forums/topic/7400-better-ratio-diff/#findComment-108883
Share on other sites

Basically, if we do the maths....

4.3/4.1=1.049 (4.9% increase)

So if a manual skylines doing +/- 2500rpm at 100km/h,

then with a 4.3 diff it should be doing 2622rpm at

the same speed...

Also means top speed will be reduced by 5%...

But at 250 or 270km/h @ 7000rpm, anyone would be mad to

try that

Link to comment
https://www.sau.com.au/forums/topic/7400-better-ratio-diff/#findComment-108964
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • My idle is set at 950rpm though - Moving the timing around 20 degrees is not really what I'd call a calm idle. That said... neither is chop, by definition. The LS ECU likes to adjust timing to hold idle as opposed to air. It'd work, but generally speaking there'd be a discrepancy in the base idle and the IACV would want to move the timing around anyway to maintain said idle. I think I'm just going to keep the timing steady anyway. Preserve my engine mounts.  My aircon is now officially regassed. As the guy was reversing I noticed my reverse lights do not operate, along with my reverse cam. This is a bit distressing, because 100% of guides talk about which wire to connect to backup cams as "the goes with the [other color] wire". Often when doing conversions. Unfortunately the R34 colour wires aren't documented Unfortunately I had a T56 Magnum gearbox with it's reverse switch, which also isn't documented. Unfortunately there's definitely not documentation for people with both of these in the one car. Unfortunately I forgot. After many hours of this, I have a reverse cam and reverse lights again. The wire going through the trans tunnel to the reverse switch had broken. Upon inspection, it looks like this one wire had about 7 spade terminals and extensions in it.. for reasons I cannot possibly comprehend. I also spent the 750 hours required to clean up the wiring behind my head unit which now looks like this: This is a monumental improvement relative to what used to be there WRT triple gauges, head unit, traction control, wideband controller, and whatever the f**k OEM stuff still exists there in various states of connectivity/needed. Next step is to check in at the Exhaust shop to see/confirm how much clearance I have, to decide what mid mufflers or 'resonators' (which are just straight through, narrower mufflers) I can add and hopefully cut out a lot of exhaust leaks, pinhole, v-band or otherwise. But first step will be to 'take a look' before the next step.
    • Fark the AFM card and Nistune, Haltech Nexus S3, DBW, cruise control, flex fuel, dis dat.  
    • It's most likely the bolt/bush where the cover bolts back wore and allowed cover to move forward.
    • Still haven't put the injectors and R35 AFM in so we can tune the bloody thing for the HG highflow it got mid last year! I think I can forecast the upgrade path to a bigger twin scroll, external gate, Haltech, flex setup, Samsonas, dis dat, etc will be .... a while away!
    • Should have taken that opportunity to slot in a twin scroll turbo setup. Maybe next time.
×
×
  • Create New...