Jump to content
SAU Community

Recommended Posts

89 model r32gts-t

8x.xxx

black

manual

sony cd deck

pioneer 6" 4 ways in door's has wiring for sub and amp, but was taken from car

3.5' turbo back kakimoto exhaust

r34 wing

k&n pod filter

bov plate(just put it in)

exelent interior no holes from bolt on's in interior and one of the best interior's you will see for an 89 model r32, car runs very well, engine is exelent, only been boosted to 12psi for 10,000km, has new fuel filter and a few lil other things ive fixed.

*** the car needs a blue slip, as it was registered in qld and i moved to nsw, has stock bov, and air box to pass no worries, i was looking for a trade, before but problems came up with my liscence, and not much point keeping my car, so yeh dont really want to let go of her but ill be taking offers at 12,000

gtst1.jpg

gtst3.jpg

gtst4.jpg

gtst9.jpg

nemzr32engine.jpg

Link to comment
https://www.sau.com.au/forums/topic/75388-syd-r32-gtst-manual-black-89-12k/
Share on other sites

  • 2 weeks later...
  • 2 weeks later...

reply's sent, i wont go any lower then this, the car is very clean, the body is a little rough, but only minor things, the interior is the best ive seen, and suspension, gear box, engine is all tight, feels very good to drive, seriously first to drive it will buy it, it hasnt been thrashed and u can feel it when u drive it and when u look at it inside, its very well taken care of

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi everyone, I'm generally new to DIY projects, and I've browsed this forum and watched a lot of youtube videos but still have a few questions   Firstly, how does spray painting interior hold up? in particular like vinyl parts, my current mode of thinking is to use methyl spirits to take off original paint, clean/prep well, light coats, no primer or clear coat    Secondly, what is recommended for the headliner and, for example (my car is a r34), the A-pillars which are some kind of other fabric material, do you think I would be successful at retrimming these? or would it be better to go down the blacking out via Dupli-Color Vinyl & Fabric Paint    Any other advice / tips / tricks for refreshing/modernising these interiors?    Thanks
    • As title says  Pm a photo with what u have  Type m style would be good As Hidding a thick front mount
    • Just note that when trying to find a short in a globe power supply, it is best to disconnect the globe as it will allow current through to earth. With it unplugged it is easier not to get confused. Also with the r32 wiring, the high beam has 2 power supplies (one when you push the switch forward and the other when you temporarily pull it back; so if it is the high beam blowing you will need to trace both circuits
    • $75 Location: Gold Coast  Can post via Australia post
    • That's a short. Find the short. It will be somewhere between that fuse and the headlight. Start by removing the plugs from the back of the headlight and dimmer switches, and measure resistance to earth. Supply side (power from the fuse) should have none. The other side should have resistance compatible with whatever globe(s) is there (which is relatively easy to say for a normal globe, perhaps not as easy to say for LEDs). Anyway, if you have very low resistance, you defo have a short. Then you just have to run the wiring like you're running the bowel of a dog (on the operating table) that has swallowed something it wasn't supposed to.
×
×
  • Create New...