Jump to content
SAU Community

Recommended Posts

  • Replies 345
  • Created
  • Last Reply

Top Posters In This Topic

guys, GTS-T wheels are a very common PCD, offset and size in general.

most of the wheels in my other thread are suitable for the GTS-T along side with other vehicles with the same or similar wheel specs.

If you want to keep an eye on what is suitable, the specs to look out for are...

PCD 114.3 5hole

+30 to +40 fronts 7 to 9 inch width

+30 to +41 rears 7.5 to 9.5 inch width.

i have listed wheels with very different specs in the same thread but i do most of the time list what vehicle they may suit. If i do not specify any vehicle makes, the chances of anything that i list, should fit the GTS-T along side any other RWD Skyline/Silvia.

this is a very good guide as to what will fit. if you have any queries, dont hesitate to PM me guys.

cheers

charles

Danny,  

no full sets to suit your car at the moment.

here is what i have found anyways..

a pair of 18x9.5 +12 with good rubber. bids close tomorrow on these.

yuugikai-img600x450-1114595707dscn1315.jpg

i can organise an additional new pair with or without rubber to complete the set.

this will work out a little cheaper than purchasing a complete new full set.

dang really after a full set

Beer Baron,  

they are a popular wheel as you know however, it will be hard to find a seller willing to separate the medaion fron the rest of his cap.

I have spotted a seller selling just caps. At the very worst, we may have to bring in a full set of caps. As i mentioned to ocean, once i locate some, i'll PM you with what's available.

this may take just a bit of time.

cheers :(

thanks, I'd appreciate that. :P if not I may just go to a parts shop next time i'm in japan and try and buy the medallion. I'm pretty sure some places I went to last time had spares like that.

I'm after a set of 18x9.5 or 10 inch rims to suit a r32 gtr with good or new semi comp rubber for around $2500 landed. Waht types of packages are out there?

Rowdy,

Ill have a look around for ya champ.

semi comp tyres are not common on used rims on auction.

Stay tuned, ill PM you with some results if any.

charles




  • Similar Content

  • Latest Posts

    • I replaced the whole clutch line with the chase bays braided hose, I think it removes that loop, is it the short hose that comes immediately off the slave or is there a drawing in the manual to find what you’re referring to? It was just re-bled when I upgraded to the nismo slave, old slave worked fine but I thought that might help, didn’t change a thing. It’s like the first half of the pedal is pushing air and then when it finally actuates the master the friction zone is tiny. Makes it practically impossible to launch the car
    • Yep, that was one of the things we learned fast in the past with our MX5. When you drive with the top down, you are effectively standing out in the sun, 100% of the time, and not getting in any shade (because roads aren't shaded generally!). Just like standing out in the middle of a field on a sunny 27C day is a bit of a bad plan, so is sitting in a MX5 without sun protection.
    • I also just ordered some Frankenstein bolts and side mounts to fit a hard top Just in case I do find one, basically so it doesn't need to be fixed to the car with only the front latch.......and then gaffa tape to keep it in place for the RTN journey from wherever I get it
    • If your temps are fine now, you probably won't have any issues with where your vents are as they don't look right up at the windscreens high pressure area, so any differences when giving it the beans for extended happy laps would be minimal, but, they should vent heaps when stuck in traffic  Much like how that reverse cowl on my SS let "visible" heat out when stationary, but, because it was basically at the windscreen my coolant temps on the Hwy actually raised because air was being fed into it at speed (110kph), to only come back down to around 90° when I got off the Hwy And your 100% correct about the NC currently not needing vents, but, if I was to add a turbo, and a oil cooler and intercooler in front of the condenserand radiator, and then take it to the track???? It is apparently a recommend requirement if I don't want to worry about coolant or oil temp issues, but, any of the above are possible scenarios, over time As it sits now, with the triple pass radiator and stock air conditioning system, I have absolutely no issues with either temps or air conditioning efficiency, I've been basically daily driving thie car for the last month, both on the Hwy, and peak hour, bumper to bumper traffic, but, that's pretty much expected from basically a standard engine  Talking about no issues daily driving, it was 39° the other day and I was sitting in bumper to bumper traffic on the M5 and then M7, with the top down, and with the air conditioning blowing nice cold air on my feet, balls, and face, well, there was one issue, my head and arms got pretty sun burnt Note to self: leave a hat and sunscreen in the car for such days 🤣
    • I would agree, unless you need something specific to the HV motor/battery side repaired or investigated, any mechanic will be able to perform normal services, but if you prefer, maybe look for a mechanic who regularly services/repairs Nissans, the VQ engines are pretty common in the Nissan lineup.  Sorry, I can't make any suggestions, I don't live in Vic.
×
×
  • Create New...