Jump to content
SAU Community

Recommended Posts

Hey all,

Came down for the dyno day, which was a rather good day if I say so myself and also put my car in on the dyno. This is the result I got on the dyno.

IMG_0034.JPG

Now even though that was the lowest power figure out of the all the turbo cars :( , it seems too high for a stock RB20DET with catback exhaust and pod filter. Converted to kw it is 144rwkw which is about 5-10kw higher than what it should be. Now I don't know much about dyno results and after checking out the latest version of HPI, there RB20DET with the same mods as me plus a FMIC made only 145rwkw which is 1kw more than mine. How can that be?

One thing I noticed in difference between my dyno result and the HPI car is that there intake temperature was 19 degrees while mine was 45 degrees? Not sure how such a high difference in temperature could occur but could it have inflated my result to give an incorrect reading?

Can anyone clear this up for me and any comments from the hyperdrive guys would be appreciated.

Cheers,

Scott

Link to comment
https://www.sau.com.au/forums/topic/77714-uncanny-dyno-results/
Share on other sites

Dynos differ depending on how they are set up.

The HPI one may not have been in shootout mode so I'd say those figures are close enough not to worry about.

Your 32 seems pretty healthy anyway which is always good to know.

The intake temps are interesting though. Was that taken at the inlet manifold or air inlet?

If you have a pod without a partition, the ambient temperature would increase the reading from the temp probe, and therefore change the reading. A higher intake temp gives a higher corrected figure.

If the temp probe is sitting against anything in the engine bay, you may get an over inflated intake temp - as the air coming into the pod is coming straight through the open bonnet.

By comparison, my intake temps were 26 degrees, but I am using a partition. The run was done within a couple of minutes of my car arriving from a long drive. Still somewhat interesting as the ambient air temp would have probably been closer to 12-14deg at the time.

This is a good example of the fact it is almost impossible to compare dyno figures 100% accurately. I am quite sure the air going into your car was not 20 degrees warmer than the air going into mine.

Dyno is for tuning - they give you a good idea of where AF ratios are at, how and where power is delivered and where there may be problems with the current setup. Peak power should be a guide only.

']dude mine made completely stock , bar an intercooler, 184.5 rwhp, so your power isnt bad at all

Not bad but how much of a gain would a catback and pod filter give? On top of that result? Because if it's a +15rwhp gain, we would still be be in the same problem again.

No not really, because then it would seem LOW not high for the mods you have.

End of they day a dyno is a tuning tool, next time you do a mod, re run it, and see what improvements you have made. Ken and Lumpy run a very professional show down there, so I doubt anything was done to make your numbers wrong

Im documenting every mod i do on antilag, so check the main site every once in a while to see what comes of it. Might give you some insight to what mods you could do yourself

Cheers

TJ

my car only got 226rwhp with similar mods :)

Only difference is mines S1 and ive heard its alot more spikey when more boost is added, it dropped 40rwhp towards the top end in one spike. Im going for a apexi power fc when i can get the $$ together to fix

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So, the other thing I've sorted is a baseline dyno run up at Unigroup's new location. The auto trans was a little unco-operative by both shifting down when the throttle was floored on the dyno (so Mark had to ramp it up more slowly than in a manual) and also by shifting up at 6,000 even in sports mode instead of the indicated redline of 7,000 Still, on a hot day it made 240rwkw at 16psi which seems about right for 300kw (400hp) through an auto at the wheels.  The shape of the curve is not quite right because it was not full throttle to about 4,500 to stop it kicking down, but until I can get a tune on the auto trans control this was the best we could do.....full boost will be well below 5,000 once that is sorted, I'll get some data logs when I can to confirm For comparison, the R32 made 255 at 12psi (at 4,500) on the same dyno with tune, n1 turbos, cam gears, big exhaust but otherwise all standard so the v37 is likely a little better out of the box. One thing that is very clear is that the standard water to air intercoolers are not up to sustained use at full throttle in warm ambient temps. After about 5 runs (so only a few minutes full throttle), it was pulling boost and timing and dropping 10-15% power. Unfortunately I didn't get that printout and the Unigroup guys are away at the moment, will try and get hold of it on their return. So, looks like a healthy engine to start modifying and the only real area of concern is the w2a heat exchangers which the aftermarket has plenty of solutions for    
    • I maintain it actually looked really nice in person. So much so that I thought "No, this is illegal" but there it was, clear as day. I think we can easily call the wing and wheels/height to be transformative. Not saying it's better than the GR Whatever, or the 86, or the WRX STI or anything of that sort (the internet says it all bolts up so you can buy best of all worlds?) but it's still at least a thing and not nearly AS bad as people say.
    • That's less offensive than the previous gen.....except for all that ugly black tupperware around the edges. Blerck!
    • I leant out the window recently and took a picture of this new WRX. It looked real damn fine in person. It's faster around a track (stock) than a (stock) GR Yaris. It's much more practical despite being heavier. It's significantly cheaper. This gen tunes really well, much better than others. .... I think they're probably a lot better than people expect.
    • WRXs are a pure pleb boring car these days. You need to get an STI to even get close to what a WRX used to be.
×
×
  • Create New...