Jump to content
SAU Community

Recommended Posts

OK, heres the story. Was on the way to work, running out of petrol, pulled into caltex, and they were out of vortex and they had no premium pumps. So i put in $10 worth of regular unleaded (i know i know)

Now since then, my petrol guage went up, then went down, down, down, WELL BELOW empty (where its never been before). I suspected it may be dodgy fuel just sending my fuel level guage haywire so i stopped into BP and put $30 worth of ultimate98 in, and it went up for a short time, then when i started driving it went right back down under E.

Anything like this happened to anyone else? It seems to head up towards the normal level when idles, but when i go anywhere, it goes right below empty. Car drives fine, no problems, just the fuel guage is stuffed. Possibly the fuel level thingy in the tank could be stuffed?

Please help :thumbsup:

Cheers

Link to comment
https://www.sau.com.au/forums/topic/78192-fuel-guage-going-haywire/
Share on other sites

I've had the guage go down past the 'E', then float back up to full again, and then back down again.... but it would have been caused by installing a new fuel pump myself and knocking the sensor off. It's always fun to never quite know how much fuel you have!

"The internet? They have that on computers now?"

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hey everyone!!  I've noticed that whenever I do my oil changes, after putting 4L in, the oil level sits at the top mark in the dipstick. This is after letting the old oil drain for a very long time too! I've checked the oil level daily for the past few mornings. It happens every time and it's confusing because all the threads say that it should take about 4.7L (With some just adding the full 5L) My next thought is to figure out if the dipstick I have is correct so could someone please tell me the length of the RB25DET engine oil dipstick?  I've checked images of some of the genuine dipsticks, but none of them have the length in it. https://justjap.com/products/genuine-nissan-engine-oil-level-dipstick-fits-nissan-r34-skyline-c34-stagea-c35-laurel-y34-cedric-gloria-rb25de-t-neo?currency=AUD&srsltid=AfmBOortQXofgmiHVRKuIaiKuygL4k0Ewp68c3isGZk0vvKOJ7Yqf3iB However.... the engraving on the genuine ones say 05002 while mine says AA000. This makes me believe that maybe I have a wrong dipstick? I just want to confirm before I buy a new one. The car is a fresh import from Japan so I don't have details of the previous owner to ask him. Thanks in advance 🙏🏾 
    • Sport. I didn’t rebleed it cause I just removed the slave and left connected.    I will change line and slave and see how it goes.  
    • Oh and how is the rattle when foot is on the clutch ?
    • Did you get the sport or track ? From what the documentation says the uniclutch has a small amount of movement to disengage.  So your story of tricky pedal setup seems common.    Hopefully you got it bled up too, as the bite point moving around is usually either plates wearing in or air in the line.     
    • There's always "MIG it up and grind it back".
×
×
  • Create New...