Jump to content
SAU Community

Recommended Posts

*Price Drop* Only asking $7k negotiable now

Putting this up to see if I get any interest, am going to sell soon due to finances as I wont be working full time in a few months.

Its a 1989 4 door GTS pillarless with a stock redtop rb20det motor, R33 automatic transmission.

Has about 95000 genuine Kms on the clock at the moment, was imported back in 1994.

Engine is stock aside from full 3inch Exhaust system (dump to cannon) and Pod intake filter.

Aftermarket Boost and Oil Pressure guage (runs about 10psi with the exhaust system)

Clarion 6 stacker audio system

has 15/65/205 rims (not sure what type) Good tread

The turbo was rebuilt when the previous owner had it around 60k kms

Just had the timing belt and water pump done, major service etc, brakes machined.(Have reciepts)

Coil packs have been replaced recently.

Cyclops immoboliser and alarm system

Has had oil changed every 4000kms

LSD diff - no whine or clunk

Has about 4months rego left

Only issues are dent in sump and the O2 sensor needs to be replaced, dent has been there since the previous owner bought it.

Body is in great nick, no dings or rust that I can see. Interior is also in good nick. Comes with the usual power windows, adjjustable suspension etc.

Here are some pictures taken earlier in the year, Im asking around $7k but as I said its mainly just to see if I get any interest at this price, also If I do sell I am going to buy a piece of shit for about $300 to get around in till I find something I like so if you have anything like this Id happy take a couple hundred off the price.

I will check this thread regularly so if you have any questions please post, my phone number is 0423277771

SkylineGT Pic1

SkylineGT Pic2

SkylineGT Pic3

SkylineGT Pic4

SkylineGT Pic5

SkylineGT Pic6

SkylineGT Pic7

Edited by Rolls

Sale fell through, buyer couldn't come up with the money.

Back up for sale, will be going in the trader next week but would prefer to see it go to a R31 enthusiast then some dick whos just going to thrash it.

  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • What can't be done with a little bit of decking board or similar timber bolted to a hub flange via 2 wheel nuts is not worth talking about.
    • I noticed something. On the tps sensor and the sensor behind the adjustment screw is adjusted towards the far left. Are these screws supposed to be centered? (this sensor was in the same position before the tune as well)  Also attached a photo of where my car usually idles at when warm (sometimes a tiny bit above that). I think I might have screwed up the calculation and it might have better than I thought lol at 750rpm still not 650rpm though.      
    • So for both general interest of engine health, and to rule out any coolant/oil issues, I organised an oil analysis done on the 125,000klm oil Results below, all good, just a bit of fuel dilution which I'm not too worried about
    • This is actually a really good way of measuring what wheels fit. If only there was a similar measurement between hub face and suspension :p That said, it's probably pretty simple to actually measure it all with the wheel off the car for the rear. The front is a bit more complex but.. 
    • Being the top Google search result for R34 wheel-related inquiries, lemme throw down my experience. I calculated that 100mm from hub face to wheel face is about the perfect fitment for my ENR34 sedan.  I've been running 18x8.5s, ET35, with a 1" spacer. So, 8.5in to mm = 216mm. 216/2 = 108mm. 108-35 = 73mm. 73+ 25 (1" to mm) = 98mm.  If you wanna get close to this on dif widths, here are the offsets you'll want: 9" - ET around 15mm 9.5" - ET around 20mm 10" - you're crazy, but ET around 30mm All these should fit perfectly on a non-widebody, non-GTR Skyline. Note that it's probably the absolute max, and you're probably better off running a couple degrees of camber in this config, but it looks great, super flush.
×
×
  • Create New...