r32 gtr front bumper on gtst, help required

[mats 32]

hi, i just bought an aftermarket 32 gtr front bumper to fit my 32 gtst though holding it up to the car it has at least a finger length of room between the guard and the end of the bumper either side. Is it worth stretching the fibreglass to fit and risk cracking it or have jetspeed given me a dodgy bar ,

if anyone has bought one, did u have the same prob?

[Sydneykid]

We have a standard GTR front bar on the GTST, the bar is actually longer where it bolts (screws actually) up to the guards. This is becuase the GTR guards flare out more than the GTST, so the bar needs to be longer to fit. Are you sure you have it pushed right in at the front, over the bumper support?

[mats 32]

yeah but the sides where it screws in are at least 7cm away from the bar(sideways), though i was told today to heat up the fibreglass to allow it to bend in easier, my panelbeater is going to give it a go this weekend. Also are u using the gtst metal support(rio) or a gtr one behind the bumper?

[GKTECH]

I have a GTR front bar on my gts-t too.. not too sure on the fitment bcuase the car is still in japan but from the look of it, it does sit out a little bit.

Greg