Thermo fans

[Guest DIRTgarage]

thank you

Anthony...we run ours ignition on....so you can have accessories on and fan/s do not run. We have not experienced any problems with this setup and is a bit neater because you dont need to run/instal a thermo switch.

[Dahtone Racing]

thats exactly wat i wanted to do thanks paul

[Ronin 09]

May also lower the temperature more than optimum and not allow it to warm up as quickly.

El Bee

I thought that the thermostat doesn't open until it reaches operating water temp. Therefore there would be no effect on warming up? I could be wong...

:confused:

[ylwgtr2]

Anthony...we run ours ignition on....so you can have accessories on and fan/s do not run. We have not experienced any problems with this setup and is a bit neater because you dont need to run/instal a thermo switch.

I see wearing the fans themselves out being a problem.....I used falcon fans with the shroud and most people think there OEM for the 34 they fit that neat....i tapped into the sender signal wire under the dash and made a control unit that has adjustable hysteresis and trigger point so no need to add sender's or switch's.Its all mounted inside the cabin next to all the diagnosis/4WD bleed connector terminal for service/adjustment time...the control unit is about the size of a matchbox so its compact.....i also wired them into the original fuse box under the bonnet and used the fuse thats marked "FAN" which is for the a/c fan so when your fan stops....logically you check the fan fuse.....the relay box also has extra relay holes that are empty so i got a genuine relay block and relay and fitted them in there also...might want to consider looking at doing it this way

[Dahtone Racing]

the cars not gonna be driven much so i can see them wearing out too quick.

wat ford fans did you use?