Avcr Installed Not Displaying Properly

[shif_tea]

Hey all,

Did a search for this but couldn't exactly find the answers. I just got my AVCR installed into my R33 the other day. They set it up at 7, 9 and 10 psi (off, a and B setting) however on my display i'm not getting any readout from throttle or rpm.

The boost setting reads properly but i'm just wondering if they haven't hooked up the other sensor wires from the AVCR to the computer or if there's some other possibility. Haven't asked them about it yet just thought i'd do some asking around first.

Cheers

[Abo Bob]

Ok the rpm probably isn't showing because there is one wire that can go to rpm or injector duty. Does it show injector duty?

As for throttle, maybe they missed a wire?

[shif_tea]

nah no display of duty either. They must not have installed it properly. I know they said they had difficulty cause the one i gave em had jap instructions ( i kinda thought they would have had some english ones around )

Anyway i've gotta take it back again so i'll ask about it at the time. thanks man

[Abo Bob]

You can get english ones from the apexiusa website

[Cubes]

I installed an AVCR for a friend of mine.

I spliced in to the the relevant wires of the loom and it displays fine.

They have simply installed the avcr and not done a 'complete' job.

How much did they charge?

I had the wiring done in under an hour.

I'm rather impressed how well it works. Slightly better than my Blitz SBC-iD. On a small turbo it has absolutely no issues forcing the turbo to hold what ever boost you dial in.

Most EBC's that are not closed loop (monitor boost levels and adjust duty cycle to obtain the desired boost level) will tend to tail off boost at high rpm. But only when pushing the turbo to its limits.