R33 Gtst Fuel Pump Install

[89CAL]

Nismo, Tomei and HKS(?) fuel pumps are all made by the same company in the same factory

pretty much identical pumps

and can anyone confirm wether that is a fuel pressure regulator or what cause if its a fuel pressure reg then it goes in the engine bay not in the fuel tank. Im not 100% on what it is though :S

[Birnie]

If you look at my pics you can see where that thing goes.

It's not a fuel pressure regulator.

What it is exactly, I'm not sure.

Some peeps have said it's a non-return valve to stop the fuel going back to the tank when the car is switched off.

Doesn't hurt to put it in and takes a whole 60 secs?

Put it in already

And yes, the pump WILL work with standard everything, injectors, and regulator.

Have fun!

[Bliksem]

Yup it's in on mine, would've been supplied for a reason...

[89CAL]

looked like a fuel pressure reg to me so i left it out

runs fine without it and im not doing it again just to put that in lol

[89CAL]

BTW

if its a non retun valve/one way valve, it would have a flow direction on it, mine doesnt

[teng]

Same here. Installed mine already. Simple if you have the guts to put your hand inside the fuel tank.

I didn't install the supplied 'one way valve' but it works great. I feel more response now.

[pedro skyline]

hi guys do anyone know how to access the skyline r33 gts t ecu???

[performance-wise]

Its located behind the passenger side kick panel (under the dash, between the door and firewall).

Cant believe this thread is still going...

[Spring&WateR]

Hey I cant see the pics... is it just me ?

[Birnie]

It's just you.

They're all there on Page 2 near the bottom.

[89CAL]

perhaps he meant the original pics? cause they dont show up for me either :S

[JSTA33]

ive got a slight problem, when i remove them 3 hoses it leaks fuel, and doesnt stop.

any tips? i used a rag but that gt soaked quite quikly, and it was a sigle bed sheet.

[Nickzke]

will a r33 fuel pump fit into a r34? or would i need to do some other modifications?

thanks

[mad082]

i don't honestly know for sure, but i don't think it would take too much to get it to work if it is different.

[datfreak]

hi, I just ordered a walbro pump for my r33gts. IT seems to have leads instead of the standard pumps screw terminals.

How do I install it? If I solder the new wires on will standard heatshrink be ok in the tank(and will not melt in petrol, and short)?

Edited January 28, 2011 by datfreak