Need Help On Installing Hybrid Fmic

[al_r33]

Hey guys,

Just in the middle of installing a Hybrid GT-Spec FMIC the instructions are f*cked up so does any one have any help to offer or pics of what it should look like.

Cheers

[Al]

I helped a mate install his Hybrid kit, and they are anything but a complete bolt up kit.

You will need;

-A GOOD metal hole saw (larger than the diametre of the pipes)

-A Drill and Tap set for the vacuum line

-A Grinder/Cutter for the front bar

-A Dremal tool to trim the corner of the eng. fan, to ensure it does not touch the Hybrid cross-over pipe.

Remember to tighten the clamps really tight, just to the point where you can see the bolts on the clamps bend.

On the hose that connects the factory cross-over pipe to the Hybrid pipe, use the factory clamp, on the factory pipe end of the hose. I think the factory pipe is a little thicker and the provided clamps is just a bee's d**k too small.

DO NOT USE any type of greasy lubricant (vasaline, grease, oil, etc) to make the hose slip over the piping easier. But a little smudge of soapy water round the outer edge of the pipe would be ok as it will dry up.

It's been ages since i did it and i told myself that i will never do it again. I probably forgot a few things, but i am sure you will figure it out .