Jump to content
SAU Community

Recommended Posts

My hicas light has started to come on after a bit of driving too. I've just put on an aftermarket steering wheel, but the bloke said that it should be ok.

I've checked the fluid level and it is all good, so i would have to guess that it is the steering wheel.

Anyone know a good place to go to get a boss kit for a momo steering wheel that doesn't screw around with hicas?

Link to comment
https://www.sau.com.au/forums/topic/8673-hicas-light/#findComment-138880
Share on other sites

  • 2 weeks later...

I am having problems with my hicas... After about 15 - 20 minutes of driving, the light comes on. There's no noticable changes to the way the car drives, and I can see the rear wheels move ever so slightly while steering to full lock. The first thing I did was to top up the power steering.

I have been trying to get the diagnostics to appear, with no luck. Either I'm doing it wrong, or there's something wrong with a sensor like brakes or speed, etc... So just to verify my procedure:

1) Turn off car, leave in neutral

2) Turn it on

3) 20o left and right 5 times.

4) Pump brake 5 times

5) Press brake again

6) Drive (or roll, really) 5 metres ahead really slow.

1) From the time I turn on the car, to the time I start the 5m drive, how many seconds do I have?

2) In step 5, do I hold the brake in slightly and heel-toe it foward, or tap it in and out?

My car is a stock R33 '95 model. The 4WS appears to be fully electric.

Link to comment
https://www.sau.com.au/forums/topic/8673-hicas-light/#findComment-172695
Share on other sites

i used to have this prob - just went away about a yr ago by itself.

whenever it came on, i just pulled over and restarted car... gone for another couple of weeks.

the only time it would come on for me was when doing long straight stretches of road that required next to no steering.

i used to drive a same long stretch of road frequently - 7 out of 10 times the hicas light would come on... ALWAYS at the same spot give or take 100m

Link to comment
https://www.sau.com.au/forums/topic/8673-hicas-light/#findComment-172727
Share on other sites

and I can see the rear wheels move ever so slightly while steering to full lock.

im dont understand what you mean here? if you are saying your rear wheels move when you are not in diagnostic mode just sitting on the spot and you turn your wheel you are wrong!

Skyline 4ws only opreates when you are travelling and not stationary unless you are in diagnostic mode!

Link to comment
https://www.sau.com.au/forums/topic/8673-hicas-light/#findComment-178026
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Exterior LEDs R34 2Dr R34 4Dr Position Lamp T10 T10 Winker front T20S T20S side T10 T10 rear T20S S25S150 Anti-hyfla relay TYPE3 TYPE3 tail T10 T20W Stop Lamps T20W T20W High Mount T16 T16 back T16 T20S number T10 T10 trunk T10 T10 Interior LED Item No.     Map Lamp BA9S single-sided     Room Lamps T10×31     Trunk Lamp T10     meter Early T6.5 pedestal     final T6.5 pedestal     NISMO T6.5 pedestal     Liquid crystal section T6.5 pedestal     Winker T6.5 pedestal     High Beam T6.5 pedestal     3 SERIES METER Early T6.5 pedestal     final T6.5 pedestal     NISMO T6.5 pedestal     air conditioner Early Liquid Crystal T3     Late LCD T4.2 Short     button T4.2 Middle     Hazard SW T3 Pedestal Short     Keyring T5     Cigar Socket T5
    • Howdy all,   I had my rb25det S2 rebuilt and finally started it today but have run into a few issues  Engine sounds like a a diesel easiest way to summarise like small ticking, gets louder when revs are slightly adjusted  The engine builder repainted the engine cover leaving no where for me to go off with lining up the CAS so have it as central as possible so not sure it that could be affecting it?, changed the gearbox fluid too but won’t seem to go into gear when running, and only 1 to 4 when off having a hard time finding 5th and reverse anyone got any ideas or a base for me to start off? much appreciated 
    • Well, no. It's an 023, which is pretty similar to an 040. Although it is hard to tell from the specs, as given.
    • Hmm. Maybe the (other thing I forgot about!) Haltech removes at least some, if not all, of the problem I described. I guess there is still the possibility of getting it wrong if the AC is set up/wired up for the Haltech as if it was in an R34 (simply because it's on a Neo), and that's playing foul with the R32 AC computer.
    • Glad it eventually came out Duncan!   I believe that might be 040. 044 is the inline pump, so has screw fittings in and out. 040 is more just drop it in fuel and the bottom is "open" (mesh) from my memory 
×
×
  • Create New...