Jump to content
SAU Community

Recommended Posts

Yes you can fit 20" rims on an R33 !! Jonny from Tempe Tyres had 22" rims on his R33 ( no idea of the offset etc. ). I must say though, 20"+ rims and Aussie roads are SO NOT suited IMO. And also ( IMO ), the only car I've seen that looked "correct" with 20"+ rims was a Lexus. But, whatever pushes your buttons.............. ;)

i love my 20s i wouldnt go any smaller

im almost 100% tempe only had 20s on the silver R33 GTR plates were WHYTRY that was the biggest AMEs ever came in

in not sure if they would fit on an R33 GTSt

but i guess it all depends on how much your going to lower it

i think 245s will be too wide for the rear

but as long as you dont drop it on its guts 225 should be ok for the front assuming you have the right offset

get ur 20's dude, they'll look hot, just dont expect them to do any favours for your handling or your wallet ie tyres cost more and wear shitloads quicker on the insides than more regular sizes. After having 19's, I wouldn't go anything over 18's on any car that I ever wanted to actually handle now... except for maybe an X5 or somethin :P

get em dude, or you'll want them forever just like I did!

not really champ

everyone has different tastes some people like 20s and chrome wheels and some dont

i dont have 20s cause im an attention seeker i have em cause thats wat a like and thats the way i want my car to look

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Re read everything that has been written about this in this thread.. Let us know if you're still confused.
    • This would be a new pump with new gears. I'm just unclear on whether it's a good idea to run more oil pump flow if you don't actually need said flow. Oil level is set a minute or so after shutting off a warm engine so wouldn't the high RPM oil level in the sump end up lower all things equal? Plan is OEM clearances, main concern in my mind is whether the OEM pump can keep up with the flow requirements of any additional oil coolers.
    • Don't do what I did, use a 300000km old housing with billet gears. The old pump probably was clearanced with saw dust, Edward Lee's special engine treatment sauce and a good odo wind back. I had oil pressure issues, then replaces pump with new housing, new billet gears and 2x track day later binned a motor due to other oil related issues due to a previous engine builder. Long story short, buy a M2 or 3 or 4 N55/S55/S58 and enjoy life.
    • Yeah. "New pump" does not have to mean "massive pump".
    • Well, can you still get an OEM pump, and by the time you're buying a Nismo/N1 etc, just buy another aftermarket pump. It's better to have the pump able to flow more if its needed, than for your pressure to drop off. At any point in time, you're replacing the oil pump in a rebuild. Aftermarket pumps are likely going to be a better economical choice, and they don't have any negatives, even if they can flow more.   Also, when you're saying "replace the pump gears" are you meaning leave a 25+ year old housing in the engine with unknown wear, and just put new gears in? As that sounds silly to me, especially if you do have that minute amount of wear, that means your new pump gears now have a little bit more clearance beside them, which means, whelp, you may not get to build a lot of oil pressure or make a lot of flow.
×
×
  • Create New...