Jump to content
SAU Community

Recommended Posts

I heard the jap model S15 (manual) injectors which flow 480cc can fit as a direct swap into the rb25det, can anyone verify this? If so would it support up to 270rwkw with fuel regulator? I have all other supporting mods.

Apparently other engines to share this style of injector are the RB25DET, the 1JZGTE, 2JZGTE and the VG30DETT.

Edited by popeye132
Link to comment
https://www.sau.com.au/forums/topic/88162-does-s15-jdm-injectors-fit-rb25dets/
Share on other sites

Yes they are a direct fit. So are USDM Ver 5/6 STi injectors (a little easier to find, usually go for about $USD150 per set of four). The toyota "J" injectors are low impedance, so no good without a ballast resistor. Mazda FD3S primary & 20B injectors will fit with Sard type collars.

So you indeed have some choices !

I looked into doing this once, but I would have had to buy 2 sets of injectors (non of the wreckers would split them) then I was going to get them cleaned and flow tested and use the best 6. Total cost was around $600 (for second hand injectors) - I then decided if I was going to pay that much I would rather spend $700-$800 for new ones rated at 550+

Edited by 4door_Sleeper
I looked into doing this once, but I would have had to buy 2 sets of injectors (non of the wreckers would split them) then I was going to get them cleaned and flow tested and use the best 6. Total cost was around $600 (for second hand injectors) - I then decided if I was going to pay that much I would rather spend $700-$800 for new ones rated at 550+

where did you get them for under $800?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...