Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

My clutch does occasionally make a funny noise, kinda like a shutter, but it doenst seem to worrying....

My car is getting the AVC-R tuned and dyno'd.... apparently it put out some fairly good results on the Genie Dyno..... I might take it to Steve as well to see how the readings compare if I can find the money at some stage...

Hmmm yes but I need to get from Perth to Myaree.... Hmmm... Time to ring around everyone I know :D

actually no i cant because i wiped the email i copied it from and i cant be bothered typing it all again basic story is i panicked cos there was a plastic burning smell coming from my car drove into a servo made a big fuss then realised it was a plastic bag hanging from my exhaust!

Hehe ... Niz is funny....

Paul I will do my best to pop in..... I am ringing around my friends to see if I can get a lift there today... I should get a copy of the dyno reading so it could be a good way of testing the relationship between the two dynos and readings....

How much for a power run though??? Does steve mind???

I am already putting this tuning on my credit card.... Damn getting paid monthly....

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Sharing results from recent Liberty Walk R35 GTR, since they are still considered as somesort of a V36 Skyline. We do them turbos too. This are high flowed SS-1 models with ball bearing conversion done.  Car have managed to pull 485awkws @ 20Psi so far pushing limitations of factory built engine. The build list for R35 GTR enthusiasts as follow : HyperGear high flowed stock turbos in SS1 (G25-660 specs) Custom titanium intake pipes. Vspec performance titanium front pipes. Vspec performance 4" titanium exhaust. Upgrade fuel pumps. 1200cc injectors. Ignition coilpacks Hks intake plenum. Hks intercooler piping. Greddy intercooler. Greddy bovs. Top-secret coolant reservoir. Emtron ecu. Straight E85. Built gear box.  
    • Nah no bearings, just slip fit.  Would be a reasonably challenging but not impossible job to modify it to run bearings but I'm hoping that's not necessary as I may have well built one myself if I end up spending hours modifying it!
    • Brumbys with good shells are bloody expensive, I've looked at 2 "cheaper" cars, and walked away from both,  plus after some research spare parts are fairly sparce I'm starting to think that I missed the boat on finding a clean one that is straight (ish) and without alot rust I'm starting to think about a old Hilux as panels and other parts are much more available as they sold tens of thousands of them I use to be indecisive but now I'm not sure
    • A Brumby would probably fit a big metal toolbox in the back... this is how it begins  
    • Picked up a new OEM boot seal for the MX5 today as the old one got ripped a bit by me being a idiot by seeing if I could fit a large metal tool box in it, it didn't fit, and ripped the seal with the corner of the tool box I am still waiting on time to get the cams and new balancer installed, as well as the repairs to the boot Time will not be an issue soon though
×
×
  • Create New...