Jump to content
SAU Community

Recommended Posts

Originally posted by Nizmo

they did it all at once - took car for drive - came back handed keys to me

Niz , I am still not convinced it is not a balance prob.

Only other thing i can think of that causes the symptoms you are describing ( note the service adviser type , non committed type reply :( ) is possibly loose front wheel bearings.

If I can get some time , I can come to your place or you come to mine ( with a chaperone if you don't trust me );)

And we can do some inspection.

cheers

ken

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by adam 32

ken; revised question...

can andrew tune it? do you know what interface they use? cos theres no external output on the ECU itself

Mate , I have never seen anyone in WA tune one yet.

Jash had one in bigred and lumpy couldn't tune it so it was binned for an Autronics when the engine was put in GTAAH.

I think it is done with smoke and mirrors:bahaha:

Cheers

Ken

ps try pm 'ing steve sst for a tuners point of view. He'sa cool and will give you a reasonably straight answer.

Originally posted by Nizmo

yeah that would be good ken :(

What ??

good I come to you or good you come to me ?

I have a jack so the latter would prolly be better but bring someone with you ( aka Paul )

My wife is suspicious of what I do as it is and a gorgeous 6' 1" blonde calling to my place alone is not going to help at all:D

cheers

Ken

Originally posted by Nizmo

ok if u want me to bring paul i will - yeah i'll come to u - um dont know what suburb u're in but wil work that out later :(

Paul has whaled here b4 , he knows .

Ps , pm ed you

cheers

Ken

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • so I need a new speedo cable 
    • Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...