Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

nah i was a bit on the slow side - its hard when you have the habbit of doing things a certain way at a certain speed and kens telling u to do one thing and your brain and common sense is telling u something different haha. Had a lot of fun - think the tyres are a little more worn now :D

doughnuts was fun wish i worked the understeer out sooner cos when the tyres started vibrating in understeer i thought that was all it was cabable of but eventually learnt to take foot off accelator then jam it back on and you get some nice sideways action out of it :D - imports dont like burnouts tho :)

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Thanks everyone! I'll take the remote apart to clean the contacts and see how it goes.
    • Balance to the force has been restored.
    • Not sure if this helps but I had a similar issue where one of the doors wouldn't lock unless I pressed the lock key twice. Turns out the door actuators were f**ked. In the Nissan service book it says to lube it every now and again, I guess put a bit a bit of wd-40. I replaced mine and haven't had a problem since.
    • 2 things. 1. If you're going to buy a ball joint puller/pusher tool that is not advertised as being for the purpose you intend to use it for, then it is up to you to make sure, either before you buy, or after you first try (and possibly fail) that it will work for that task. 2. WTF? Putting HICAS balljoints back into a car implies retaining HICAS, which is just....dumb. HICAS can lick my left one.
    • After cleaning the contacts in the remote, if it has rubber carbon pads on the buttons, give them a little wipe with a 2B pencil to add some fresh carbon back. Just a little wipe. Not too much.
×
×
  • Create New...