Jump to content
SAU Community

Blocked Rubber Hoses ...

Coupe-This

By Coupe-This,
in General Maintenance

 Share

Recommended Posts

Coupe-This Grand Master

Coupe-This

Posted
Posted

I have just installed a turbotech boost controller onto my car, and the boost solonoid is just sort of sitting there, i have kinked over the hose and cable tied it so nothing can get it. But i remember from my vl turbo you could get, or well it had a couple of rubber hoses about an inch long (stretching my memory) and a capped end. They were towards the rear of the plenum facing the same direction as the throttle body.

does anyone know what im talking about, as i would like to put on of those capped off rubber hoses on the solonoid.

Link to comment
https://www.sau.com.au/forums/topic/89528-blocked-rubber-hoses/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • soviet_merlin
      Beers and skylines Fatz style

      By soviet_merlin · Posted

      Holy mother of downforce!  
    • GTSBoy
      Wont start unless i have the pedal to the floor

      By GTSBoy · Posted

      Look to cold enrichment then?
    • GTSBoy
      R34 RB20DE NEO + T ONLY

      By GTSBoy · Posted

      See my post here If you put the Haltech in, you won't have to worry about any of that. And, in case you're worrying about my lack of credentials in doing your exact swap, I put a Neo in an R32. There has never been a stock boost solenoid near my car and the Neo's ECU has never cared. Nor should it, because it is electronically impossible for it to care.
    • GTSBoy
      Help Understand GTT Boost Setup

      By GTSBoy · Posted

      That's 100% wrong. Did you wire in the boost sensor? If you did not, then that is 101% your answer. Neo ECUs do suck a bit.
    • Sxnjeet
      R34 RB20DE NEO + T ONLY

      By Sxnjeet · Posted

      Hello, I'm trying to make this thread basically the thread with all the answers to common questions regarding specifically the RB20 DE NEO + T engine, that comes in the R34. Answers will and only should be provided by those who have done this conversion or actually have some relevant real life experience please. Please feel free to ask questions in the comments if you have any so other members can answer. I feel like this thread is really needed, especially with more Americans buying (unknowingly going to regret it too) rb20 neo r34s. My first question being - What do you guys use for tuning? I have purchased a haltech elite 2500 Plug and play kit for the rb25det NEO because the ecu plug is the same, but I am unsure if any of the pins would need to be repined to match. Second question that I see asked very often - After this conversion, did you install the boost solenoid/ actuator? I see many people doing a + T setup on their rb20 NEOs while running stock RB25DET NEO ECUs with no tune. I am wondering how they are going about doing that and consistently abusing the car because many of these people have had these untuned setups running for a very long time. That was my original plan, but my engine cuts out at 5 psi of boost using the stock ecu with no tune and no boost solenoid/actuator.
×
×
  • Create New...