Jump to content
SAU Community

Recommended Posts

Hey guys

This has been bothering me for a while, but coming into summer, I'd like to get it ironed out.

Not always, but quite frequently when i drive, HOT air seems to pour out of the small hoses located above your feet behind the dash. (Basically if you've got your left foot on the foot rest or clutch, its going to get warm fast).

The problem only occurs when the a/c is off, and if i turn it on, it seems to stop. Had a passanger yesterday that wasn't too impressed when her shoes nearly caught fire!

Any advice would be much appreciated.

Cheers

Link to comment
https://www.sau.com.au/forums/topic/89695-melting-feet/
Share on other sites

Does it happen when the climate control is on or off? When I had the CC off completely I would get hot air coming through but if I turned it on(without A/C) it would try to keep it at whatever temp was set-no more melty feet for me :)

Link to comment
https://www.sau.com.au/forums/topic/89695-melting-feet/#findComment-1619460
Share on other sites

Check the sensors.

Do the air-con diagnostic and it will tell you if something is wrong.

Most likely the outside air temp sensor is fux0red.

Thanks for that mate, how do you actually run the diagnostic?

Link to comment
https://www.sau.com.au/forums/topic/89695-melting-feet/#findComment-1620173
Share on other sites

I've actually got this problem too. Only started to notice it after I'd taken my car in to get tuned, so naturally I thought they must have done something wrong. Thanks for the solution guys! (He he, shoes catching on fire, not good!)

"Mmmm, unexplained bacon."

Link to comment
https://www.sau.com.au/forums/topic/89695-melting-feet/#findComment-1621530
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • If there's a next time, next exit after mine is Costco 😛
    • OK. But what about parts of the block that, when assembled, were twisted into a position that pushed into the void space, which, when disassembled, then released that force and opened back up, thus putting the grout into tension? Would effectively just pull the cast iron off the grout at the interface, leaving a tiny void and benefitting not much at all. Swings, and roundabouts. It's like putting something tiny into the fleshlight and finding out you needed a smaller one, to perhaps follow your area of expertise.
    • Nah. You buy a kit that has shorter tubes.
    • I didnt present too many conclusions because I wanted your opinions and feedback based on your own experiences. I don't know the exact material, but it is similar to concrete and therfor only has valuable strength in compression. The forces on the set material once the head is removed would mostly be in compression since the grout wants to retain its shape and the block wants to return to its relaxed state since it's still within the elastic region. The grout would theoretically make the block more rigid. The exact amount would take a better setup on my end. Thought experiment: Instead of aliens, twist your favorite fleshlite. Now fill it with grout and allow it to sit for a week. Now try to twist it again. Observe what you see. Now get your other one and blow into it. Observe what you see. Now put it into a can and fill the space between your fleshlite and the can. After it sets blow into it. Less movement in torsion and less expansion i hope.   
×
×
  • Create New...