Jump to content
SAU Community

Recommended Posts

I had a good look at these before buying mine, and decided against it.. Main problem was that they didn't make it in a manual, and the NEO RB25DET in mine is a well known and understood beast in Aus, where I wasn't sure about the VQ25DET - details were hard to find...

So I don't know if you're gaining much going to the NM35's from the later (post june 2000) GF_WGNC34's... :-)

Ian

- and yes, I still haven't had time to upload my picks from saturday...

- and I went to the show and shine on Sunday - there was a LOT of interest in my stagea (wife was out in the R34 so I couldn't take that), I drove it in and parked it with the parked cars - not the cars in the comp - and it rapidly had a crowd around it... In fact it was the third photo put up from the day - see http://www.skylinesaustralia.com/forums/in...showtopic=89590

Ian's Stagea, for all those too lazy to search

it was the last one of those I was referring to, as it is up at the start of the post.. Next time we should all go, and I'll even wash my car and enter it in the 'other' category!

Have a read of the post, mine is mentioned from here http://www.skylinesaustralia.com/forums/in...0entry1618230

Ian

it was the last one of those I was referring to, as it is up at the start of the post.. Next time we should all go, and I'll even wash my car and enter it in the 'other' category!

Sounds good to me.....l'll be up for going to at least one SAU event.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • so I need a new speedo cable 
    • Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...