Jump to content
SAU Community

Recommended Posts

I know the twin turbo 3ltr sequential twin turbo supra has a lot of potential. But I was just wondering if anyone knows what rwkw are achievable with the following mods

- After market cooler

- Power FC or equivalent

- full exhaust system from turbos back.

- boost increase with stock turbos

From reading these forums and from personal experience these mods on a RB25 with 10-12psi of boost ~200rwkw seems to achievable. I know the supra will make a lot more power than this but how much more?

Edited by Munna
Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/
Share on other sites

  • Replies 46
  • Created
  • Last Reply

Top Posters In This Topic

Well.. when we were at the dyno day with OCAU a supra running pretty much the same setup except it was running a SAFC2 and a boost controller I believe.. he reeled off about 240kw..

Thanks thats about what I would have expected anyone else? What 1/4 mile times would a supra with these mods and a good suspention setup get?

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1623994
Share on other sites

My brother has a '95 Supra RZ with those mods, plus a Trust pod filter, Bosch 044, AVCR and a Malpassi fuel pressure regulator and is making 272rwkw at 14psi. He could be making a little bit more, but needs a new dump pipe.

"They taste like burning!"

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1624554
Share on other sites

The dump isn't stock; it's a 3 inch dump. But he was told that a 3" dump was too large for the stock turbos on a Supra as the wastegate can't control the boost properly (needs the back pressure). So he's had a restricter put into the dump until he gets a new one.

"They taste like burning!"

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1624659
Share on other sites

Got a friend who got there 1996 TT (6spd) Supra dynoed with the following setup:

1. Aftermarket Front Mount Intercooler

2. Stock Air box/Turbos/Boost setting 10psi or there abouts

3. Catback- OR turbo back exhaust (unsure)

4. 18" rims.

result:

214rwkw at unigroup.

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1624706
Share on other sites

2JZ-GTE into an R33 is stupidity in my opinion. 2JZ with the 6 speed costs an absolute fortune, and an RB26 can make similar power. If you really want the BIG CUBE straight six, you could probably build a killer RB30DETT for less than a 2JZ engine swap. The cost of installing a 2JZ would be phenomenal.

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1624976
Share on other sites

Keep a Supra engine in a supra, and an RB in a Skyline..

If you want extra power in a Gts-t.. go and buy an R32 GT-R than you'll even it up.. what a skyline lacks sometimes in raw power, it makes up for round the corners.. ATTESSA.. and a couple of other areas..

Personally I would love a Supra TT - but for 40k i'd be hard pressed to not buy a R33 GT-R..

They are definately quite a nice car.. I love the look of them.. so sleek.. with a set of rims, lowered with no wing.. droooolling..

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1625025
Share on other sites

Thanks everyone I know that the supra is quicker over the 1/4 than the r33 gtst from the factory.

How would a R33 GTS-T fare against a the supra both in street trim at this level of modification assuming they both have a decent suspention/tyre setup. Keeping in mind the supra weighs 200kg's more.

I know that the skyline is capable of high 12's what can the supra do?

Link to comment
https://www.sau.com.au/forums/topic/90052-toyota-supra/#findComment-1625140
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Sharing results from recent Liberty Walk R35 GTR, since they are still considered as somesort of a V36 Skyline. We do them turbos too. This are high flowed SS-1 models with ball bearing conversion done.  Car have managed to pull 485awkws @ 20Psi so far pushing limitations of factory built engine. The build list for R35 GTR enthusiasts as follow : HyperGear high flowed stock turbos in SS1 (G25-660 specs) Custom titanium intake pipes. Vspec performance titanium front pipes. Vspec performance 4" titanium exhaust. Upgrade fuel pumps. 1200cc injectors. Ignition coilpacks Hks intake plenum. Hks intercooler piping. Greddy intercooler. Greddy bovs. Top-secret coolant reservoir. Emtron ecu. Straight E85. Built gear box.  
    • Nah no bearings, just slip fit.  Would be a reasonably challenging but not impossible job to modify it to run bearings but I'm hoping that's not necessary as I may have well built one myself if I end up spending hours modifying it!
    • Brumbys with good shells are bloody expensive, I've looked at 2 "cheaper" cars, and walked away from both,  plus after some research spare parts are fairly sparce I'm starting to think that I missed the boat on finding a clean one that is straight (ish) and without alot rust I'm starting to think about a old Hilux as panels and other parts are much more available as they sold tens of thousands of them I use to be indecisive but now I'm not sure
    • A Brumby would probably fit a big metal toolbox in the back... this is how it begins  
    • Picked up a new OEM boot seal for the MX5 today as the old one got ripped a bit by me being a idiot by seeing if I could fit a large metal tool box in it, it didn't fit, and ripped the seal with the corner of the tool box I am still waiting on time to get the cams and new balancer installed, as well as the repairs to the boot Time will not be an issue soon though
×
×
  • Create New...