Project: Rb30dett Lc Torana

[Wrath]

Hey guys,

My 32 GTR front cut just arrived the other day and while my mates go about pulling the engine out I am going to tackle cutting down the DREADED wiring loom.... I have had a fair bit of experience with looms so that means i get the job....

My question is......... is there anything I should know before I start? any tips, tricks or things to avoid with these GTR looms.... any specail wires or sensors that I need to look out for? and any problems people have had with these looms?

Thanks

Ohh and does anyone have any HI-RES wiring diagrams? I cant get one good enough to be able to read the colours of the wires

[Wrath]

Ok I have the diagrams, spent some time going over them and my gameplan was cut the wiring loom down to just the ECCS(W3) wiring and the important stuff from the main engine harness (W-1).

Does this sound right to any of your elecs out there? and is there anything from the main body harness or HICAS that I need for engine operation?

[Fitzpatrick Speed Works]

your spot on the money you dont need any of the hicas or atttessa loom only w1 and w3 will help you!! I hate the iring in these cars best option is to cut it all out and start again but that cost money if you are patient you can get the standard loom happening, good luck mate.

[Wrath]

what about the diagnosis connector in the main harness? should i keep that in, and if i remove the hicas wires for it, will it still work properly?