Jump to content
SAU Community

Recommended Posts

  • Replies 58
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

I had 5 runs and left just as the burnouts started at 9. Yeh should be a fairly low 12 with some proper setting up. .

One of my runs - Had a great start with a 1.70 60foot (lowest for the night), hit 2nd gear pulling damm hard and the bloody ashtray fold out thing in front of the gear stick comes crashing out and blocking me going into 3rd gear!! Damm thing was full of loose change so it ended sending it all over the floor of the car haha..Cost me a good run!!

The ashtray ended up in the back seat somewhere..couldn't believe it when happened grrr

The 12.5 was at a 1.7 60 ft 1.79 to be exact..did the 1.70 on the ashtray affected run :)

Had a few close runs with MADGTR 2nite, he did a best of 12.4 i think.

Well done :)

Interesting, the first (and only time) i went to the drags with my stock turbos, making about 250rwkw i ran 12.4@111mph... there was more in it but the strip was crap for traction that day i was told by other regulars. Axle tramping all the way through 1st and 2nd sucks.

Do you feel there is anymore MPH in your current setup?

The R32 is also lighter so i would of expected it to be a little quicker than my R33.

Had a run out at WSID tonight..

12.5 at 112mph :D with a 1.7 60 foot

Perfect 60 ft , i only wish i could do that in mine but then again i have an extra 100 odd kg on me !

Good to see MADGTR having a go , if i knew i would have beeing there to match race him , as we have the same set up in our cars .

What was your trap speed Paul ?

The track would have been very average last night. Their hasn't been any racing on the track for about 10-14 days due to bad weather. It's also been about 3-4 days since I last seen the sun so the track temp would have been very low.

The run that you missed 3rd I remember my reaction from the launch (it looked way faster than the other runs) thinking "this has gotta be a low 12 for sure" then you missed 3rd :D

Their is certainly a 12.0-12.2 in the car, just a matter of time.

Good nite, pity about the weather (not many cars).

Edited by benm

becuase an r32 gtr intercooler can run about .9-1 bar efficently before it starts to restrict the turbos(run out of flow capacity). an r34 gtr cooler flows a bit better from memory its about 1.2 bar

Edited by mr 32

I think it should be a tad bit higher with a good driver (no offense), quick gear changes, and revving it out all the way to 8 :P

Hell wrxhoon did 118mph in his 34 gtr with stsandard mods with gtss. the heads a bit better than it is on the 32 and 33 so hes got a bit more power .....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Ok gotcha, so one post to fpr  another to bov  and I have the mishimoto boost controller and a link g4+ so I’d just have the tuner set it up properly. For the last two from plenum post throttle to  ecu/ boost controller, I know that I have a hose coming from the ecu that I was confused about so I assume that’s what connect to the boost controller from the ecu? And then the last is just from plenum to boost controller then to wastegate?
    • From there, it was just a quick electrical check, prime the oil and start her up Which, is not what happened. 1. Bloody seppo Aeropro battery holder. Not only was it too tall for the battery (which I'll forgive them for, I have another battery the same nominal size that is taller than Neil's one, but the bracket is a fixed height so the battery was spaced up) But the thing that really shits me is the hardware to hold it on requires a 7/32 Hex key. WTF. No-one will ever be able to remove or install the damn thing without a hex key they don't own 2. Kill switch no longer worked once the console was installed. Neil mentioned above he had to adjust the length but it no longer cleared the console once installed. Sorted. 3. Suspiciously, the brake light holders were hanging in the boot with no globes. Sure enough the stopper on the brake pedal was missing so they are always on unless the kill switch is activated. Will pick one up tomorrow (turns out 32 and 33 don't use the same stopper) 4. All that sorted, I turned on the kill switch, turned the key to ACC. Nothing. Turned it to IGN. Nothing. Checked some fuses and found the main IGN in the boot was missing which improved things once it was replaced. Now ECU and dash lights turn on with IGN but still no fuel pump. 5. Turned it to Start....ECU on, no fuel pump, no starter. Plus the voltage dropped straight to 9v.  I suspect the starter is f**ked but am going to have to work through it all and see what is happening, really looks like more than one issue. Does anyone have the R33 fuse box key with the circuit it sources from (eg BAT, ACC, IGN, SRT etc) and supplies? I can find a translated list showing Amps and circuit without supply circuit, and I can find supply circuit without Amps and target circuit.
    • 3rd time lucky, the AAC is now all plumbed up after getting some final fittings All set up under the plenum of maximum access
    • OK, so the weight has been bugging because it was really low. I did it again today and got a more believable answer at 1246 without driver And with a 93kg driver I'm pretty sure the car was still slightly on the quickjack last time meaning the full weight was not on the scales  
×
×
  • Create New...